md: range check slot number when manually adding a spare.
authorNeilBrown <neilb@suse.de>
Thu, 13 Jan 2011 22:14:34 +0000 (09:14 +1100)
committerNeilBrown <neilb@suse.de>
Thu, 13 Jan 2011 22:14:34 +0000 (09:14 +1100)
When adding a spare to an active array, we should check the slot
number, but allow it to be larger than raid_disks if a reshape
is being prepared.

Apply the same test when adding a device to an
array-under-construction.  It already had most of the test in place,
but not quite all.

Signed-off-by: NeilBrown <neilb@suse.de>
drivers/md/md.c

index 5e3714f..6658513 100644 (file)
@@ -2479,6 +2479,10 @@ slot_store(mdk_rdev_t *rdev, const char *buf, size_t len)
                        if (rdev2->raid_disk == slot)
                                return -EEXIST;
 
+               if (slot >= rdev->mddev->raid_disks &&
+                   slot >= rdev->mddev->raid_disks + rdev->mddev->delta_disks)
+                       return -ENOSPC;
+
                rdev->raid_disk = slot;
                if (test_bit(In_sync, &rdev->flags))
                        rdev->saved_raid_disk = slot;
@@ -2496,7 +2500,8 @@ slot_store(mdk_rdev_t *rdev, const char *buf, size_t len)
                        /* failure here is OK */;
                /* don't wakeup anyone, leave that to userspace. */
        } else {
-               if (slot >= rdev->mddev->raid_disks)
+               if (slot >= rdev->mddev->raid_disks &&
+                   slot >= rdev->mddev->raid_disks + rdev->mddev->delta_disks)
                        return -ENOSPC;
                rdev->raid_disk = slot;
                /* assume it is working */