Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C
specification.
+- i2c-analog-filter
+ Enable analog filter for i2c lines.
+
+- i2c-digital-filter
+ Enable digital filter for i2c lines.
+
+- i2c-digital-filter-width-ns
+ Width of spikes which can be filtered by digital filter
+ (i2c-digital-filter). This width is specified in nanoseconds.
+
+- i2c-analog-filter-cutoff-frequency
+ Frequency that the analog filter (i2c-analog-filter) uses to distinguish
+ which signal to filter. Signal with higher frequency than specified will
+ be filtered out. Only lower frequency will pass (this is applicable to
+ a low-pass analog filter). Typical value should be above the normal
+ i2c bus clock frequency (clock-frequency).
+ Specified in Hz.
+
- interrupts
interrupts used by the device.