remoteproc: stm32: clear MCU PDDS at firmware start

When remoteproc stops a firmware, it sets the MCU PDDS flag, allowing
the platform to reach the Standby power mode if needed.
Symmetrically, clear this flag before running a firmware.
This fixes the issue where the system goes to Standby mode when the
MCU crashes while MPU is in CSTOP mode.

Signed-off-by: Fabien Dessenne <fabien.dessenne@st.com>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

diff --git a/drivers/remoteproc/stm32_rproc.c b/drivers/remoteproc/stm32_rproc.c
index e2da719..1c95913 100644 (file)
--- a/drivers/remoteproc/stm32_rproc.c
+++ b/drivers/remoteproc/stm32_rproc.c
@@ -383,10 +383,21 @@ static void stm32_rproc_add_coredump_trace(struct rproc *rproc)
 
 static int stm32_rproc_start(struct rproc *rproc)
 {
+       struct stm32_rproc *ddata = rproc->priv;
        int err;
 
        stm32_rproc_add_coredump_trace(rproc);
 
+       /* clear remote proc Deep Sleep */
+       if (ddata->pdds.map) {
+               err = regmap_update_bits(ddata->pdds.map, ddata->pdds.reg,
+                                        ddata->pdds.mask, 0);
+               if (err) {
+                       dev_err(&rproc->dev, "failed to clear pdds\n");
+                       return err;
+               }
+       }
+
        err = stm32_rproc_set_hold_boot(rproc, false);
        if (err)
                return err;