[media] af9035: correct demod i2c addresses

Chip uses so called 8-bit i2c addresses, but on bus there is of
course correct 7-bit addresses with rw bit as lsb - verified
with oscilloscope.

Lets still use correct addresses in driver.

Signed-off-by: Antti Palosaari <crope@iki.fi>
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>

diff --git a/drivers/media/usb/dvb-usb-v2/af9035.c b/drivers/media/usb/dvb-usb-v2/af9035.c
index cb82043..4df9486 100644 (file)
--- a/drivers/media/usb/dvb-usb-v2/af9035.c
+++ b/drivers/media/usb/dvb-usb-v2/af9035.c
@@ -772,9 +772,9 @@ static int af9035_download_firmware(struct dvb_usb_device *d,
                /* tell the slave I2C address */
                tmp = state->eeprom[EEPROM_2ND_DEMOD_ADDR];
 
-               /* use default I2C address if eeprom has no address set */
+               /* Use default I2C address if eeprom has no address set */
                if (!tmp)
-                       tmp = 0x3a;
+                       tmp = 0x1d << 1; /* 8-bit format used by chip */
 
                if ((state->chip_type == 0x9135) ||
                                (state->chip_type == 0x9306)) {
@@ -837,9 +837,9 @@ static int af9035_read_config(struct dvb_usb_device *d)
        u8 tmp;
        u16 tmp16;
 
-       /* demod I2C "address" */
-       state->af9033_i2c_addr[0] = 0x38;
-       state->af9033_i2c_addr[1] = 0x3a;
+       /* Demod I2C address */
+       state->af9033_i2c_addr[0] = 0x1c;
+       state->af9033_i2c_addr[1] = 0x1d;
        state->af9033_config[0].adc_multiplier = AF9033_ADC_MULTIPLIER_2X;
        state->af9033_config[1].adc_multiplier = AF9033_ADC_MULTIPLIER_2X;
        state->af9033_config[0].ts_mode = AF9033_TS_MODE_USB;
@@ -878,12 +878,13 @@ static int af9035_read_config(struct dvb_usb_device *d)
        state->ir_type = state->eeprom[EEPROM_IR_TYPE];
 
        if (state->dual_mode) {
-               /* read 2nd demodulator I2C address */
+               /* Read 2nd demodulator I2C address. 8-bit format on eeprom */
                tmp = state->eeprom[EEPROM_2ND_DEMOD_ADDR];
                if (tmp)
-                       state->af9033_i2c_addr[1] = tmp;
+                       state->af9033_i2c_addr[1] = tmp >> 1;
 
-               dev_dbg(&intf->dev, "2nd demod I2C addr=%02x\n", tmp);
+               dev_dbg(&intf->dev, "2nd demod I2C addr=%02x\n",
+                       state->af9033_i2c_addr[1]);
        }
 
        for (i = 0; i < state->dual_mode + 1; i++) {