ti: qspi: set flash quad bit based on quad support flag

Update op_mode_rx flag based on CONFIG_QSPI_QUAD_SUPPORT flag,
instead of platform.

Signed-off-by: Vishal Mahaveer <vishalm@ti.com>
Reviewed-by: Jagan Teki <jteki@openedev.com>

diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index 3356c0f..af40ec8 100644 (file)
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -106,7 +106,6 @@ static void ti_spi_setup_spi_register(struct ti_qspi_slave *qslave)
        slave->memory_map = (void *)MMAP_START_ADDR_DRA;
 #else
        slave->memory_map = (void *)MMAP_START_ADDR_AM43x;
-       slave->op_mode_rx = 8;
 #endif
 
 #ifdef CONFIG_QSPI_QUAD_SUPPORT
@@ -114,6 +113,7 @@ static void ti_spi_setup_spi_register(struct ti_qspi_slave *qslave)
                        QSPI_SETUP0_NUM_D_BYTES_8_BITS |
                        QSPI_SETUP0_READ_QUAD | QSPI_CMD_WRITE |
                        QSPI_NUM_DUMMY_BITS);
+       slave->op_mode_rx = SPI_OPM_RX_QOF;
 #else
        memval |= QSPI_CMD_READ | QSPI_SETUP0_NUM_A_BYTES |
                        QSPI_SETUP0_NUM_D_BYTES_NO_BITS |