ARM: dts: imx6qdl-sabreauto: Add sensors

The following sensors are on I2C3 on the baseboard:
* isil,isl29023 light sensor
* fsl,mag3110 magnetometer
* fsl,mma8451 accelerometer

Added under i2cmux/i2c@1 because they're not otherwise accessible.

These are all supported by iio with following configs:
* CONFIG_SENSORS_ISL29018
* CONFIG_MAG3110
* CONFIG_MMA8452

Tested with raw reads from iio sysfs.

Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index 0e28e36..a59a0fd 100644 (file)
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
@@ -155,6 +155,27 @@
                                gpio-controller;
                                #gpio-cells = <2>;
                        };
+
+                       light-sensor@44 {
+                               compatible = "isil,isl29023";
+                               reg = <0x44>;
+                               interrupt-parent = <&gpio5>;
+                               interrupts = <17 IRQ_TYPE_EDGE_FALLING>;
+                       };
+
+                       magnetometer@e {
+                               compatible = "fsl,mag3110";
+                               reg = <0x0e>;
+                               interrupt-parent = <&gpio2>;
+                               interrupts = <29 IRQ_TYPE_EDGE_RISING>;
+                       };
+
+                       accelerometer@1c {
+                               compatible = "fsl,mma8451";
+                               reg = <0x1c>;
+                               interrupt-parent = <&gpio6>;
+                               interrupts = <31 IRQ_TYPE_LEVEL_LOW>;
+                       };
                };
        };
 };