* @ack_base: Base ack address. If zero then the chip is clear on read.
* Using zero value is possible with @use_ack bit.
* @wake_base: Base address for wake enables. If zero unsupported.
- * @type_base: Base address for irq type. If zero unsupported.
- * @virt_reg_base: Base addresses for extra config regs.
+ * @type_base: Base address for irq type. If zero unsupported. Deprecated,
+ * use @config_base instead.
+ * @virt_reg_base: Base addresses for extra config regs. Deprecated, use
+ * @config_base instead.
* @config_base: Base address for IRQ type config regs. If null unsupported.
* @irq_reg_stride: Stride to use for chips where registers are not contiguous.
* @init_ack_masked: Ack all masked interrupts once during initalization.
* @ack_invert: Inverted ack register: cleared bits for ack.
* @clear_ack: Use this to set 1 and 0 or vice-versa to clear interrupts.
* @wake_invert: Inverted wake register: cleared bits are wake enabled.
- * @type_invert: Invert the type flags.
+ * @type_invert: Invert the type flags. Deprecated, use config registers
+ * instead.
* @type_in_mask: Use the mask registers for controlling irq type. Use this if
* the hardware provides separate bits for rising/falling edge
* or low/high level interrupts and they should be combined into
* @irqs: Descriptors for individual IRQs. Interrupt numbers are
* assigned based on the index in the array of the interrupt.
* @num_irqs: Number of descriptors.
- * @num_type_reg: Number of type registers.
+ * @num_type_reg: Number of type registers. Deprecated, use config registers
+ * instead.
* @num_virt_regs: Number of non-standard irq configuration registers.
- * If zero unsupported.
+ * If zero unsupported. Deprecated, use config registers
+ * instead.
* @num_config_bases: Number of config base registers.
* @num_config_regs: Number of config registers for each config base register.
* @handle_pre_irq: Driver specific callback to handle interrupt from device
* @handle_post_irq: Driver specific callback to handle interrupt from device
* after handling the interrupts in regmap_irq_handler().
* @set_type_virt: Driver specific callback to extend regmap_irq_set_type()
- * and configure virt regs.
+ * and configure virt regs. Deprecated, use @set_type_config
+ * callback and config registers instead.
* @set_type_config: Callback used for configuring irq types.
* @irq_drv_data: Driver specific IRQ data which is passed as parameter when
* driver specific pre/post interrupt handler is called.