ARM: mvebu: ClearFog make sure that SATA and UART images are buildable

SATA and UART ClearFog imaages are not buildable as ENV_SECT_SIZE is not defined
set values for both possible targets

Signed-off-by: Dennis Gilmore <dennis@ausil.us>

diff --git a/board/solidrun/clearfog/Kconfig b/board/solidrun/clearfog/Kconfig
index e8c3f53..cf95258 100644 (file)
--- a/board/solidrun/clearfog/Kconfig
+++ b/board/solidrun/clearfog/Kconfig
@@ -50,9 +50,9 @@ config ENV_OFFSET
 config ENV_SECT_SIZE
        hex "Environment Sector-Size"
        # Use SPI flash erase block size of 4 KiB
-       default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI
+       default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI || MVEBU_SPL_BOOT_DEVICE_SATA
        # Use optimistic 64 KiB erase block, will vary between actual media
-       default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC
+       default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC || MVEBU_SPL_BOOT_DEVICE_UART
 
 config SYS_SPI_U_BOOT_OFFS
        hex "address of u-boot payload in SPI flash"