#include <linux/notifier.h>
#include <linux/extcon-provider.h>
#include <linux/regmap.h>
-#include <linux/gpio.h>
-#include <linux/gpio/consumer.h>
#include <linux/mfd/axp20x.h>
/* Power source status register */
AXP288_BC_DET_STAT_REG = 0x2f,
};
-enum axp288_mux_select {
- EXTCON_GPIO_MUX_SEL_PMIC = 0,
- EXTCON_GPIO_MUX_SEL_SOC,
-};
-
enum axp288_extcon_irq {
VBUS_FALLING_IRQ = 0,
VBUS_RISING_IRQ,
struct device *dev;
struct regmap *regmap;
struct regmap_irq_chip_data *regmap_irqc;
- struct gpio_desc *gpio_mux_cntl;
int irq[EXTCON_IRQ_END];
struct extcon_dev *edev;
unsigned int previous_cable;
}
no_vbus:
- /*
- * If VBUS is absent Connect D+/D- lines to PMIC for BC
- * detection. Else connect them to SOC for USB communication.
- */
- if (info->gpio_mux_cntl)
- gpiod_set_value(info->gpio_mux_cntl,
- vbus_attach ? EXTCON_GPIO_MUX_SEL_SOC
- : EXTCON_GPIO_MUX_SEL_PMIC);
-
extcon_set_state_sync(info->edev, info->previous_cable, false);
if (info->previous_cable == EXTCON_CHG_USB_SDP)
extcon_set_state_sync(info->edev, EXTCON_USB, false);
{
struct axp288_extcon_info *info;
struct axp20x_dev *axp20x = dev_get_drvdata(pdev->dev.parent);
- struct axp288_extcon_pdata *pdata = pdev->dev.platform_data;
- int ret, i, pirq, gpio;
+ int ret, i, pirq;
info = devm_kzalloc(&pdev->dev, sizeof(*info), GFP_KERNEL);
if (!info)
info->regmap = axp20x->regmap;
info->regmap_irqc = axp20x->regmap_irqc;
info->previous_cable = EXTCON_NONE;
- if (pdata)
- info->gpio_mux_cntl = pdata->gpio_mux_cntl;
platform_set_drvdata(pdev, info);
return ret;
}
- /* Set up gpio control for USB Mux */
- if (info->gpio_mux_cntl) {
- gpio = desc_to_gpio(info->gpio_mux_cntl);
- ret = devm_gpio_request(&pdev->dev, gpio, "USB_MUX");
- if (ret < 0) {
- dev_err(&pdev->dev,
- "failed to request the gpio=%d\n", gpio);
- return ret;
- }
- gpiod_direction_output(info->gpio_mux_cntl,
- EXTCON_GPIO_MUX_SEL_PMIC);
- }
-
for (i = 0; i < EXTCON_IRQ_END; i++) {
pirq = platform_get_irq(pdev, i);
if (pirq < 0)