target: Add workaround for zero-length control CDB handling
authorNicholas Bellinger <nab@linux-iscsi.org>
Fri, 13 Jan 2012 20:01:34 +0000 (12:01 -0800)
committerNicholas Bellinger <nab@linux-iscsi.org>
Wed, 18 Jan 2012 08:30:22 +0000 (08:30 +0000)
This patch adds a work-around for handling zero allocation length
control CDBs (type SCF_SCSI_CONTROL_SG_IO_CDB) that was causing an
OOPs with the following raw calls:

   # sg_raw -v /dev/sdd 3 0 0 0 0 0
   # sg_raw -v /dev/sdd 0x1a 0 1 0 0 0

This patch will follow existing zero-length handling for data I/O
and silently return with GOOD status.  This addresses the zero length
issue, but the proper long-term resolution for handling arbitary
allocation lengths will be to refactor out data-phase handling in
individual CDB emulation logic within target_core_cdb.c

Reported-by: Roland Dreier <roland@purestorage.com>
Cc: <stable@vger.kernel.org>
Signed-off-by: Nicholas Bellinger <nab@linux-iscsi.org>
drivers/target/target_core_transport.c

index 2869fb7..50d6911 100644 (file)
@@ -3759,6 +3759,11 @@ transport_allocate_control_task(struct se_cmd *cmd)
        struct se_task *task;
        unsigned long flags;
 
+       /* Workaround for handling zero-length control CDBs */
+       if ((cmd->se_cmd_flags & SCF_SCSI_CONTROL_SG_IO_CDB) &&
+           !cmd->data_length)
+               return 0;
+
        task = transport_generic_get_task(cmd, cmd->data_direction);
        if (!task)
                return -ENOMEM;
@@ -3830,6 +3835,14 @@ int transport_generic_new_cmd(struct se_cmd *cmd)
        else if (!task_cdbs && (cmd->se_cmd_flags & SCF_SCSI_DATA_SG_IO_CDB)) {
                cmd->t_state = TRANSPORT_COMPLETE;
                atomic_set(&cmd->t_transport_active, 1);
+
+               if (cmd->t_task_cdb[0] == REQUEST_SENSE) {
+                       u8 ua_asc = 0, ua_ascq = 0;
+
+                       core_scsi3_ua_clear_for_request_sense(cmd,
+                                       &ua_asc, &ua_ascq);
+               }
+
                INIT_WORK(&cmd->work, target_complete_ok_work);
                queue_work(target_completion_wq, &cmd->work);
                return 0;