net: e1000: Use virt_to_phys() instead of pci_virt_to_mem()

Using (dm_)pci_virt_to_mem() is incorrect to translate the virtual
address in local DRAM to a physical address. The correct macro here
is virt_to_phys() so switch to using this macro.

As virt_to_bus() is now not used any more, this patch also removes
both definitions (DM and non-DM).

This issue was detected while testing the e1000 driver on the MIPS
Octeon III platform, which needs address translation.

Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Aaron Williams <awilliams@marvell.com>
Cc: Chandrakala Chavva <cchavva@marvell.com>

diff --git a/drivers/net/e1000.c b/drivers/net/e1000.c
index 372f6c3..6d6bf8c 100644 (file)
--- a/drivers/net/e1000.c
+++ b/drivers/net/e1000.c
@@ -45,12 +45,6 @@ tested on both gig copper and gig fiber boards
 
 #define TOUT_LOOP   100000
 
-#ifdef CONFIG_DM_ETH
-#define virt_to_bus(devno, v)  dm_pci_virt_to_mem(devno, (void *) (v))
-#else
-#define virt_to_bus(devno, v)  pci_virt_to_mem(devno, (void *) (v))
-#endif
-
 #define E1000_DEFAULT_PCI_PBA  0x00000030
 #define E1000_DEFAULT_PCIE_PBA 0x000a0026
 
@@ -5385,7 +5379,7 @@ static int _e1000_transmit(struct e1000_hw *hw, void *txpacket, int length)
        txp = tx_base + tx_tail;
        tx_tail = (tx_tail + 1) % 8;
 
-       txp->buffer_addr = cpu_to_le64(virt_to_bus(hw->pdev, nv_packet));
+       txp->buffer_addr = cpu_to_le64(virt_to_phys(nv_packet));
        txp->lower.data = cpu_to_le32(hw->txd_cmd | length);
        txp->upper.data = 0;