serial: stm32: use mapbase instead of membase for DMA

Building this driver with a 64-bit dma_addr_t type results in
a compiler warning:

drivers/tty/serial/stm32-usart.c: In function 'stm32_of_dma_rx_probe':
drivers/tty/serial/stm32-usart.c:746:20: error: cast from pointer to integer of different size [-Werror=pointer-to-int-cast]
drivers/tty/serial/stm32-usart.c: In function 'stm32_of_dma_tx_probe':
drivers/tty/serial/stm32-usart.c:818:20: error: cast from pointer to integer of different size [-Werror=pointer-to-int-cast]

While the type conversion here is harmless, this hints at a different
problem: we pass an __iomem pointer into a DMA engine, which expects
a phys_addr_t. This happens to work because stm32 has no MMU and
ioremap() is an identity mapping here, but it's still an incorrect
API use. Using dma_addr_t is doubly wrong here, because that would
be the result of dma_map_single() rather than the physical address.

Using the mapbase instead fixes multiple issues:

- the warning is gone
- we don't go through ioremap in error
- the cast is gone, making it use the correct resource_size_t/phys_addr_t
  type in the process.

Fixes: 3489187204eb ("serial: stm32: adding dma support")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Reviewed-by: Gerald Baeza <gerald.baeza@st.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 4d3001b..2adb678 100644 (file)
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -743,7 +743,7 @@ static int stm32_of_dma_rx_probe(struct stm32_port *stm32port,
 
        /* Configure DMA channel */
        memset(&config, 0, sizeof(config));
-       config.src_addr = (dma_addr_t)port->membase + ofs->rdr;
+       config.src_addr = port->mapbase + ofs->rdr;
        config.src_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE;
 
        ret = dmaengine_slave_config(stm32port->rx_ch, &config);
@@ -815,7 +815,7 @@ static int stm32_of_dma_tx_probe(struct stm32_port *stm32port,
 
        /* Configure DMA channel */
        memset(&config, 0, sizeof(config));
-       config.dst_addr = (dma_addr_t)port->membase + ofs->tdr;
+       config.dst_addr = port->mapbase + ofs->tdr;
        config.dst_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE;
 
        ret = dmaengine_slave_config(stm32port->tx_ch, &config);