gpio: mxc: Remove reliance on <linux/gpio.h>

This is a driver so we should only include <linux/gpio/driver.h>.
However this driver was using gpio_get_value() to fetch the
current value of a GPIO used as IRQ line to determine trigger
direction, so we need a better way than looping over the
global GPIO numberspace.

Fix this by just calling the .get() function in the GPIO chip,
as we don't want to end up creating a consumer dependency
on ourselves.

Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Fabio Estevam <fabio.estevam@nxp.com>
Acked-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/drivers/gpio/gpio-mxc.c b/drivers/gpio/gpio-mxc.c
index 5245a2f..11ec722 100644 (file)
--- a/drivers/gpio/gpio-mxc.c
+++ b/drivers/gpio/gpio-mxc.c
@@ -30,8 +30,6 @@
 #include <linux/platform_device.h>
 #include <linux/slab.h>
 #include <linux/gpio/driver.h>
-/* FIXME: for gpio_get_value() replace this with direct register read */
-#include <linux/gpio.h>
 #include <linux/of.h>
 #include <linux/of_device.h>
 #include <linux/bug.h>
@@ -174,7 +172,6 @@ static int gpio_set_irq_type(struct irq_data *d, u32 type)
        struct mxc_gpio_port *port = gc->private;
        u32 bit, val;
        u32 gpio_idx = d->hwirq;
-       u32 gpio = port->gc.base + gpio_idx;
        int edge;
        void __iomem *reg = port->base;
 
@@ -190,13 +187,13 @@ static int gpio_set_irq_type(struct irq_data *d, u32 type)
                if (GPIO_EDGE_SEL >= 0) {
                        edge = GPIO_INT_BOTH_EDGES;
                } else {
-                       val = gpio_get_value(gpio);
+                       val = port->gc.get(&port->gc, gpio_idx);
                        if (val) {
                                edge = GPIO_INT_LOW_LEV;
-                               pr_debug("mxc: set GPIO %d to low trigger\n", gpio);
+                               pr_debug("mxc: set GPIO %d to low trigger\n", gpio_idx);
                        } else {
                                edge = GPIO_INT_HIGH_LEV;
-                               pr_debug("mxc: set GPIO %d to high trigger\n", gpio);
+                               pr_debug("mxc: set GPIO %d to high trigger\n", gpio_idx);
                        }
                        port->both_edges |= 1 << gpio_idx;
                }