* ath5k_hw_set_ack_bitrate - set bitrate for ACKs
*
* @ah: The &struct ath5k_hw
- * @high: Flag to determine if we want to use high transmition rate
+ * @high: Flag to determine if we want to use high transmission rate
* for ACKs or not
*
* If high flag is set, we tell hw to use a set of control rates based on
- * the current transmition rate (check out control_rates array inside reset.c).
+ * the current transmission rate (check out control_rates array inside reset.c).
* If not hw just uses the lowest rate available for the current modulation
* scheme being used (1Mbit for CCK and 6Mbits for OFDM).
*/
* register). After this MAC and Baseband are
* disabled and a full reset is needed to come
* back. This way we save as much power as possible
- * without puting the card on full sleep.
+ * without putting the card on full sleep.
*/
int ath5k_hw_on_hold(struct ath5k_hw *ah)
{
/*
* Put chipset on warm reset...
*
- * Note: puting PCI core on warm reset on PCI-E cards
+ * Note: putting PCI core on warm reset on PCI-E cards
* results card to hang and always return 0xffff... so
* we ingore that flag for PCI-E cards. On PCI cards
* this flag gets cleared after 64 PCI clocks.
/*
* Put chipset on warm reset...
*
- * Note: puting PCI core on warm reset on PCI-E cards
+ * Note: putting PCI core on warm reset on PCI-E cards
* results card to hang and always return 0xffff... so
* we ingore that flag for PCI-E cards. On PCI cards
* this flag gets cleared after 64 PCI clocks.