Remove annoying debug printout for PHY less boards.

PHY less board prints out lots of "read wrong ...":
read wrong value : mii_id 3,mii_reg 2, base e0102320
read wrong value : mii_id 3,mii_reg 3, base e0102320
UEC: PHY is Generic MII (ffffffff)
read wrong value : mii_id 3,mii_reg 4, base e0102320
read wrong value : mii_id 3,mii_reg 0, base e0102320
read wrong value : mii_id 3,mii_reg 1, base e0102320
read wrong value : mii_id 3,mii_reg 1, base e0102320
read wrong value : mii_id 3,mii_reg 5, base e0102320
read wrong value : mii_id 3,mii_reg 1, base e0102320
read wrong value : mii_id 3,mii_reg 1, base e0102320
read wrong value : mii_id 3,mii_reg 5, base e0102320
FSL UEC0: Full Duplex
FSL UEC0: Speed 100BT
FSL UEC0: Link is up
Using FSL UEC0 device

Make this printout depend on UEC_VERBOSE_DEBUG and
remove its definition in uec_phy.c

Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>

diff --git a/drivers/qe/uec_phy.c b/drivers/qe/uec_phy.c
index f890d4f..c549b6b 100644 (file)
--- a/drivers/qe/uec_phy.c
+++ b/drivers/qe/uec_phy.c
@@ -28,7 +28,6 @@
 
 #if defined(CONFIG_QE)
 
-#define UEC_VERBOSE_DEBUG
 #define ugphy_printk(format, arg...)  \
        printf(format "\n", ## arg)
 
@@ -114,7 +113,7 @@ int uec_read_phy_reg (struct eth_device *dev, int mii_id, int regnum)
        /* Read MII management status  */
        value = (u16) in_be32 (&ug_regs->miimstat);
        if (value == 0xffff)
-               ugphy_warn
+               ugphy_vdbg
                        ("read wrong value : mii_id %d,mii_reg %d, base %08x",
                         mii_id, mii_reg, (u32) & (ug_regs->miimcfg));