overlays: README: Refer to WLAN where possible
authorPhil Elwell <phil@raspberrypi.com>
Wed, 8 Sep 2021 13:10:32 +0000 (14:10 +0100)
committerPhil Elwell <phil@raspberrypi.com>
Wed, 8 Sep 2021 13:50:55 +0000 (14:50 +0100)
Signed-off-by: Phil Elwell <phil@raspberrypi.com>
arch/arm/boot/dts/overlays/README

index ec769b2..890e926 100644 (file)
@@ -235,7 +235,7 @@ Params:
         sd_debug                Enable debug output from SD driver (default off)
 
         sdio_overclock          Clock (in MHz) to use when the MMC framework
-                                requests 50MHz for the SDIO/WiFi interface.
+                                requests 50MHz for the SDIO/WLAN interface.
 
         tx_lpi_timer            Set the delay in microseconds between going idle
                                 and entering the low power state (default 600).
@@ -611,7 +611,7 @@ Params: swap_lr                 Reverse the channel allocation, which will also
 
 
 Name:   balena-fin
-Info:   Overlay that enables WiFi, Bluetooth and the GPIO expander on the
+Info:   Overlay that enables WLAN, Bluetooth and the GPIO expander on the
         balenaFin carrier board for the Raspberry Pi Compute Module 3/3+ Lite.
 Load:   dtoverlay=balena-fin
 Params: <None>
@@ -694,7 +694,7 @@ Params: <None>
 
 
 Name:   disable-wifi
-Info:   Disable onboard WiFi on Pi 3B, 3B+, 3A+, 4B and Zero W.
+Info:   Disable onboard WLAN on Pi 3B, 3B+, 3A+, 4B and Zero W.
 Load:   dtoverlay=disable-wifi
 Params: <None>
 
@@ -2723,7 +2723,7 @@ Name:   sdhost
 Info:   Selects the bcm2835-sdhost SD/MMC driver, optionally with overclock.
         N.B. This overlay is designed for situations where the mmc driver is
         the default, so it disables the other (mmc) interface - this will kill
-        WiFi on a Pi3. If this isn't what you want, either use the sdtweak
+        WLAN on a Pi3. If this isn't what you want, either use the sdtweak
         overlay or the new sd_* dtparams of the base DTBs.
 Load:   dtoverlay=sdhost,<param>=<val>
 Params: overclock_50            Clock (in MHz) to use when the MMC framework