return;
}
+ /*
+ * Possible situations when BT needs to take over for receive,
+ * at the same time where STA needs to response to AP's frame(s),
+ * reduce the tx power of the required response frames, by that,
+ * allow the concurrent BT receive & WiFi transmit
+ * (BT - ANT A, WiFi -ANT B), without interference to one another
+ *
+ * Reduced tx power apply to control frames only (ACK/Back/CTS)
+ * when indicated by the BT config command
+ */
basic.kill_ack_mask = priv->kill_ack_mask;
basic.kill_cts_mask = priv->kill_cts_mask;
- basic.reduce_txpower = priv->reduced_txpower;
+ if (priv->reduced_txpower)
+ basic.reduce_txpower = IWLAGN_BT_REDUCED_TX_PWR;
basic.valid = priv->bt_valid;
/*
return need_update;
}
+/*
+ * Upon RSSI changes, sends a bt config command with following changes
+ * 1. enable/disable "reduced control frames tx power
+ * 2. update the "kill)ack_mask" and "kill_cts_mask"
+ *
+ * If "reduced tx power" is enabled, uCode shall
+ * 1. ACK/Back/CTS rate shall reduced to 6Mbps
+ * 2. not use duplciate 20/40MHz mode
+ */
static bool iwlagn_fill_txpower_mode(struct iwl_priv *priv,
struct iwl_bt_uart_msg *uart_msg)
{
IWLAGN_BT_VALID_REDUCED_TX_PWR | \
IWLAGN_BT_VALID_3W_LUT)
+#define IWLAGN_BT_REDUCED_TX_PWR BIT(0)
+
#define IWLAGN_BT_DECISION_LUT_SIZE 12
struct iwl_basic_bt_cmd {
u8 bt3_timer_t2_value;
__le16 bt4_reaction_time; /* unused */
__le32 bt3_lookup_table[IWLAGN_BT_DECISION_LUT_SIZE];
+ /*
+ * bit 0: use reduced tx power for control frame
+ * bit 1 - 7: reserved
+ */
u8 reduce_txpower;
u8 reserved;
__le16 valid;