ddr: socfpga: Enable ARM64 Non-Secure SDRAM ECC Access

The ECC registers in the SDRAM HMC Adapter should always
be accessible (both when ECC is enabled and disabled).
Currently, the registers are accessible only when ECC is enabled.

The ECC Enabled bit is used to determine the status of
ECC by later OSes so always allow access.

Signed-off-by: Thor Thayer <thor.thayer@linux.intel.com>
Reviewed-by: Ley Foon Tan <ley.foon.tan@intel.com>

diff --git a/drivers/ddr/altera/sdram_agilex.c b/drivers/ddr/altera/sdram_agilex.c
index cc7679a..0cbcd14 100644 (file)
--- a/drivers/ddr/altera/sdram_agilex.c
+++ b/drivers/ddr/altera/sdram_agilex.c
@@ -143,9 +143,6 @@ int sdram_mmr_init_full(struct udevice *dev)
                setbits_le32(plat->hmc + ERRINTEN,
                             DDR_HMC_ERRINTEN_DERRINTEN_EN_SET_MSK);
 
-               /* Enable non-secure writes to HMC Adapter for SDRAM ECC */
-               writel(FW_HMC_ADAPTOR_MPU_MASK, FW_HMC_ADAPTOR_REG_ADDR);
-
                if (!cpu_has_been_warmreset())
                        sdram_init_ecc_bits(&bd);
        } else {
@@ -158,6 +155,9 @@ int sdram_mmr_init_full(struct udevice *dev)
                              DDR_HMC_ECCCTL2_AWB_EN_SET_MSK));
        }
 
+       /* Enable non-secure reads/writes to HMC Adapter for SDRAM ECC */
+       writel(FW_HMC_ADAPTOR_MPU_MASK, FW_HMC_ADAPTOR_REG_ADDR);
+
        sdram_size_check(&bd);
 
        priv->info.base = bd.bi_dram[0].start;

diff --git a/drivers/ddr/altera/sdram_s10.c b/drivers/ddr/altera/sdram_s10.c
index cf586ac..93c15dd 100644 (file)
--- a/drivers/ddr/altera/sdram_s10.c
+++ b/drivers/ddr/altera/sdram_s10.c
@@ -307,9 +307,6 @@ int sdram_mmr_init_full(struct udevice *dev)
                              DDR_HMC_ECCCTL2_AWB_EN_SET_MSK));
                hmc_ecc_writel(plat, DDR_HMC_ERRINTEN_INTMASK, ERRINTENS);
 
-               /* Enable non-secure writes to HMC Adapter for SDRAM ECC */
-               writel(FW_HMC_ADAPTOR_MPU_MASK, FW_HMC_ADAPTOR_REG_ADDR);
-
                /* Initialize memory content if not from warm reset */
                if (!cpu_has_been_warmreset())
                        sdram_init_ecc_bits(&bd);
@@ -323,6 +320,9 @@ int sdram_mmr_init_full(struct udevice *dev)
                              DDR_HMC_ECCCTL2_AWB_EN_SET_MSK));
        }
 
+       /* Enable non-secure reads/writes to HMC Adapter for SDRAM ECC */
+       writel(FW_HMC_ADAPTOR_MPU_MASK, FW_HMC_ADAPTOR_REG_ADDR);
+
        sdram_size_check(&bd);
 
        priv->info.base = bd.bi_dram[0].start;