--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-only
+
+/dts-v1/;
+
+#include "msm8916-pm8916.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+
+/ {
+ aliases {
+ serial0 = &blsp1_uart2;
+ };
+
+ chosen {
+ stdout-path = "serial0";
+ };
+
+ reserved-memory {
+ /* Additional memory used by Samsung firmware modifications */
+ tz-apps@85500000 {
+ reg = <0x0 0x85500000 0x0 0xb00000>;
+ no-map;
+ };
+ };
+
+ gpio-keys {
+ compatible = "gpio-keys";
+
+ pinctrl-0 = <&gpio_keys_default>;
+ pinctrl-names = "default";
+
+ label = "GPIO Buttons";
+
+ volume-up-button {
+ label = "Volume Up";
+ gpios = <&msmgpio 107 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_VOLUMEUP>;
+ };
+
+ home-button {
+ label = "Home";
+ gpios = <&msmgpio 109 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_HOMEPAGE>;
+ };
+ };
+
+ gpio-hall-sensor {
+ compatible = "gpio-keys";
+
+ pinctrl-0 = <&gpio_hall_sensor_default>;
+ pinctrl-names = "default";
+
+ label = "GPIO Hall Effect Sensor";
+
+ hall-sensor-switch {
+ label = "Hall Effect Sensor";
+ gpios = <&msmgpio 52 GPIO_ACTIVE_LOW>;
+ linux,input-type = <EV_SW>;
+ linux,code = <SW_LID>;
+ linux,can-disable;
+ };
+ };
+};
+
+&blsp_i2c4 {
+ status = "okay";
+
+ fuelgauge@36 {
+ compatible = "maxim,max77849-battery";
+ reg = <0x36>;
+
+ maxim,rsns-microohm = <10000>;
+ maxim,over-heat-temp = <600>;
+ maxim,over-volt = <4400>;
+
+ interrupt-parent = <&msmgpio>;
+ interrupts = <121 IRQ_TYPE_EDGE_FALLING>;
+
+ pinctrl-0 = <&fuelgauge_int_default>;
+ pinctrl-names = "default";
+ };
+};
+
+&blsp_i2c2 {
+ status = "okay";
+
+ light-sensor@10 {
+ compatible = "capella,cm3323";
+ reg = <0x10>;
+ };
+
+ accelerometer@1d {
+ compatible = "st,lis2hh12";
+ reg = <0x1d>;
+
+ vdd-supply = <&pm8916_l17>;
+ vddio-supply = <&pm8916_l5>;
+
+ interrupt-parent = <&msmgpio>;
+ interrupts = <115 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "INT1";
+
+ st,drdy-int-pin = <1>;
+ mount-matrix = "0", "1", "0",
+ "-1", "0", "0",
+ "0", "0", "1";
+
+ pinctrl-0 = <&accel_int_default>;
+ pinctrl-names = "default";
+ };
+};
+
+&blsp1_uart2 {
+ status = "okay";
+};
+
+&pm8916_resin {
+ linux,code = <KEY_VOLUMEDOWN>;
+ status = "okay";
+};
+
+/* FIXME: Replace with MAX77849 MUIC when driver is available */
+&pm8916_usbin {
+ status = "okay";
+};
+
+&pronto {
+ status = "okay";
+
+ iris {
+ compatible = "qcom,wcn3660b";
+ };
+};
+
+&sdhc_1 {
+ pinctrl-0 = <&sdc1_clk_on &sdc1_cmd_on &sdc1_data_on>;
+ pinctrl-1 = <&sdc1_clk_off &sdc1_cmd_off &sdc1_data_off>;
+ pinctrl-names = "default", "sleep";
+
+ status = "okay";
+};
+
+&sdhc_2 {
+ pinctrl-0 = <&sdc2_clk_on &sdc2_cmd_on &sdc2_data_on &sdc2_cd_on>;
+ pinctrl-1 = <&sdc2_clk_off &sdc2_cmd_off &sdc2_data_off &sdc2_cd_off>;
+ pinctrl-names = "default", "sleep";
+
+ cd-gpios = <&msmgpio 38 GPIO_ACTIVE_LOW>;
+
+ status = "okay";
+};
+
+&usb {
+ dr_mode = "peripheral";
+ extcon = <&pm8916_usbin>;
+
+ status = "okay";
+};
+
+&usb_hs_phy {
+ extcon = <&pm8916_usbin>;
+};
+
+&smd_rpm_regulators {
+ vdd_l1_l2_l3-supply = <&pm8916_s3>;
+ vdd_l4_l5_l6-supply = <&pm8916_s4>;
+ vdd_l7-supply = <&pm8916_s4>;
+
+ s3 {
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1300000>;
+ };
+
+ s4 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2100000>;
+ };
+
+ l1 {
+ regulator-min-microvolt = <1225000>;
+ regulator-max-microvolt = <1225000>;
+ };
+
+ l2 {
+ regulator-min-microvolt = <1200000>;
+ regulator-max-microvolt = <1200000>;
+ };
+
+ l4 {
+ regulator-min-microvolt = <2050000>;
+ regulator-max-microvolt = <2050000>;
+ };
+
+ l5 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ };
+
+ l6 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ };
+
+ l7 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+ };
+
+ l8 {
+ regulator-min-microvolt = <2850000>;
+ regulator-max-microvolt = <2900000>;
+ };
+
+ l9 {
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ };
+
+ l10 {
+ regulator-min-microvolt = <2700000>;
+ regulator-max-microvolt = <2800000>;
+ };
+
+ l11 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2950000>;
+ regulator-system-load = <200000>;
+ regulator-allow-set-load;
+ };
+
+ l12 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2950000>;
+ };
+
+ l13 {
+ regulator-min-microvolt = <3075000>;
+ regulator-max-microvolt = <3075000>;
+ };
+
+ l14 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <3300000>;
+ };
+
+ l15 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <3300000>;
+ };
+
+ l16 {
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <3300000>;
+ };
+
+ l17 {
+ regulator-min-microvolt = <2850000>;
+ regulator-max-microvolt = <2850000>;
+ };
+
+ l18 {
+ regulator-min-microvolt = <2700000>;
+ regulator-max-microvolt = <2700000>;
+ };
+};
+
+&msmgpio {
+ accel_int_default: accel-int-default-state {
+ pins = "gpio115";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ fuelgauge_int_default: fuelgauge-int-default-state {
+ pins = "gpio121";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ gpio_keys_default: gpio-keys-default-state {
+ pins = "gpio107", "gpio109";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+
+ gpio_hall_sensor_default: gpio-hall-sensor-default-state {
+ pins = "gpio52";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+};
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-only
+
+/dts-v1/;
+
+#include "msm8916-samsung-gt5-common.dtsi"
+
+/ {
+ model = "Samsung Galaxy Tab A 9.7 (2015)";
+ compatible = "samsung,gt510", "qcom,msm8916";
+ chassis-type = "tablet";
+
+ clk_pwm: pwm {
+ compatible = "clk-pwm";
+ #pwm-cells = <2>;
+
+ clocks = <&gcc GCC_GP2_CLK>;
+
+ pinctrl-0 = <&motor_pwm_default>;
+ pinctrl-names = "default";
+ };
+
+ reg_motor_vdd: regulator-motor-vdd {
+ compatible = "regulator-fixed";
+ regulator-name = "motor_vdd";
+ regulator-min-microvolt = <3000000>;
+ regulator-max-microvolt = <3000000>;
+
+ gpio = <&msmgpio 76 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+
+ pinctrl-0 = <&motor_en_default>;
+ pinctrl-names = "default";
+ };
+
+ reg_tsp_1p8v: regulator-tsp-1p8v {
+ compatible = "regulator-fixed";
+ regulator-name = "tsp_1p8v";
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <1800000>;
+
+ gpio = <&msmgpio 73 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+
+ pinctrl-0 = <&tsp_en_default>;
+ pinctrl-names = "default";
+ };
+
+ reg_tsp_3p3v: regulator-tsp-3p3v {
+ compatible = "regulator-fixed";
+ regulator-name = "tsp_3p3v";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+
+ gpio = <&msmgpio 73 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+
+ vibrator {
+ compatible = "pwm-vibrator";
+
+ pwms = <&clk_pwm 0 100000>;
+ pwm-names = "enable";
+
+ vcc-supply = <®_motor_vdd>;
+ };
+};
+
+&blsp_i2c5 {
+ status = "okay";
+
+ touchscreen@4a {
+ compatible = "atmel,maxtouch";
+ reg = <0x4a>;
+ interrupt-parent = <&msmgpio>;
+ interrupts = <13 IRQ_TYPE_LEVEL_LOW>;
+
+ vdd-supply = <®_tsp_1p8v>;
+ vdda-supply = <®_tsp_3p3v>;
+
+ reset-gpios = <&msmgpio 114 GPIO_ACTIVE_LOW>;
+
+ pinctrl-0 = <&tsp_int_rst_default>;
+ pinctrl-names = "default";
+ };
+};
+
+&msmgpio {
+ motor_en_default: motor-en-default-state {
+ pins = "gpio76";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ motor_pwm_default: motor-pwm-default-state {
+ pins = "gpio50";
+ function = "gcc_gp2_clk_a";
+ };
+
+ tsp_en_default: tsp-en-default-state {
+ pins = "gpio73";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ tsp_int_rst_default: tsp-int-rst-default-state {
+ pins = "gpio13", "gpio114";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+};