cfg80211: wext does not need to set monitor channel in managed mode

There is not a valid reason to attempt setting the monitor channel
while in managed mode. Since this code path only deals with this mode,
remove the code block.

Johannes: I'll note that the comment indicated it was for backward
compatibility, but the code wasn't functional since switching the
monitor channel isn't supported (any more?) when in managed mode, as
that mode owns the channel configuration. Additionally, since monitor
can't be done on a managed mode interface, this would only have had
any effect to start with if a separate monitor interface is present,
in which case it's better to change the channel through that anyway,
if even possible.

Signed-off-by: Jorge Ramirez-Ortiz <jorge.ramirez-ortiz@linaro.org>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

diff --git a/net/wireless/wext-sme.c b/net/wireless/wext-sme.c
index 9951638..c434f19 100644 (file)
--- a/net/wireless/wext-sme.c
+++ b/net/wireless/wext-sme.c
@@ -105,30 +105,7 @@ int cfg80211_mgd_wext_siwfreq(struct net_device *dev,
                        goto out;
        }
 
-
        wdev->wext.connect.channel = chan;
-
-       /*
-        * SSID is not set, we just want to switch monitor channel,
-        * this is really just backward compatibility, if the SSID
-        * is set then we use the channel to select the BSS to use
-        * to connect to instead. If we were connected on another
-        * channel we disconnected above and reconnect below.
-        */
-       if (chan && !wdev->wext.connect.ssid_len) {
-               struct cfg80211_chan_def chandef = {
-                       .width = NL80211_CHAN_WIDTH_20_NOHT,
-                       .center_freq1 = freq,
-               };
-
-               chandef.chan = ieee80211_get_channel(&rdev->wiphy, freq);
-               if (chandef.chan)
-                       err = cfg80211_set_monitor_channel(rdev, &chandef);
-               else
-                       err = -EINVAL;
-               goto out;
-       }
-
        err = cfg80211_mgd_wext_connect(rdev, wdev);
  out:
        wdev_unlock(wdev);