ARM: dts: sun8i: r40: Add device node and RGMII pinmux node for GMAC

The R40 SoC has a GMAC (gigabit capable Ethernet controller). Add a
device node for it. The only publicly available board for this SoC
uses an RGMII PHY. Add a pinmux node for it as well.

Since this SoC also has an old 10/100 Mbps EMAC, which also has an
MDIO bus controller, the MDIO bus for the GMAC is labeled "gmac_mdio".

Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
Signed-off-by: Chen-Yu Tsai <wens@csie.org>

diff --git a/arch/arm/boot/dts/sun8i-r40.dtsi b/arch/arm/boot/dts/sun8i-r40.dtsi
index 173dcc1..bd97ca3 100644 (file)
--- a/arch/arm/boot/dts/sun8i-r40.dtsi
+++ b/arch/arm/boot/dts/sun8i-r40.dtsi
@@ -265,6 +265,19 @@
                        #interrupt-cells = <3>;
                        #gpio-cells = <3>;
 
+                       gmac_rgmii_pins: gmac-rgmii-pins {
+                               pins = "PA0", "PA1", "PA2", "PA3",
+                                      "PA4", "PA5", "PA6", "PA7",
+                                      "PA8", "PA10", "PA11", "PA12",
+                                      "PA13", "PA15", "PA16";
+                               function = "gmac";
+                               /*
+                                * data lines in RGMII mode use DDR mode
+                                * and need a higher signal drive strength
+                                */
+                               drive-strength = <40>;
+                       };
+
                        i2c0_pins: i2c0-pins {
                                pins = "PB0", "PB1";
                                function = "i2c0";
@@ -451,6 +464,27 @@
                        #size-cells = <0>;
                };
 
+               gmac: ethernet@1c50000 {
+                       compatible = "allwinner,sun8i-r40-gmac";
+                       syscon = <&ccu>;
+                       reg = <0x01c50000 0x10000>;
+                       interrupts = <GIC_SPI 85 IRQ_TYPE_LEVEL_HIGH>;
+                       interrupt-names = "macirq";
+                       resets = <&ccu RST_BUS_GMAC>;
+                       reset-names = "stmmaceth";
+                       clocks = <&ccu CLK_BUS_GMAC>;
+                       clock-names = "stmmaceth";
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+                       status = "disabled";
+
+                       gmac_mdio: mdio {
+                               compatible = "snps,dwmac-mdio";
+                               #address-cells = <1>;
+                               #size-cells = <0>;
+                       };
+               };
+
                gic: interrupt-controller@1c81000 {
                        compatible = "arm,gic-400";
                        reg = <0x01c81000 0x1000>,