pinctrl: bcm2835: Clear the event latch register when disabling interrupts

It's possible to hit a race condition if interrupts are generated on a GPIO
pin when the IRQ line in question is being disabled.

If the interrupt is freed, bcm2835_gpio_irq_disable() is called which
disables the event generation sources (edge, level). If an event occurred
between the last disabling of hard IRQs and the write to the event
source registers, a bit would be set in the GPIO event detect register
(GPEDSn) which goes unacknowledged by bcm2835_gpio_irq_handler()
so Linux complains loudly.

There is no per-GPIO mask register, so when disabling GPIO interrupts
write 1 to the relevant bit in GPEDSn to clear out any stale events.

Signed-off-by: Jonathan Bell <jonathan@raspberrypi.org>
Acked-by: Stephen Warren <swarren@wwwdotorg.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/drivers/pinctrl/bcm/pinctrl-bcm2835.c b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
index efcf2a2..6177315 100644 (file)
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -473,6 +473,8 @@ static void bcm2835_gpio_irq_disable(struct irq_data *data)
 
        spin_lock_irqsave(&pc->irq_lock[bank], flags);
        bcm2835_gpio_irq_config(pc, gpio, false);
+       /* Clear events that were latched prior to clearing event sources */
+       bcm2835_gpio_set_bit(pc, GPEDS0, gpio);
        clear_bit(offset, &pc->enabled_irq_map[bank]);
        spin_unlock_irqrestore(&pc->irq_lock[bank], flags);
 }