ARM: dts: bcm2712-rpi-5-b: Use common LED labels

As of 6.6, the names of the labels on the Pi LEDs was swapped to match
the upstream code, i.e. led_act rather than act_led.

Apply the same change to Pi 5.

Signed-off-by: Phil Elwell <phil@raspberrypi.com>

diff --git a/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts b/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
index d960bc4..3631b79 100644 (file)
--- a/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
+++ b/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
@@ -63,14 +63,14 @@
        leds: leds {
                compatible = "gpio-leds";
 
-               pwr_led: led-pwr {
+               led_pwr: led-pwr {
                        label = "PWR";
                        gpios = <&rp1_gpio 44 GPIO_ACTIVE_LOW>;
                        default-state = "off";
                        linux,default-trigger = "none";
                };
 
-               act_led: led-act {
+               led_act: led-act {
                        label = "ACT";
                        gpios = <&gio_aon 9 GPIO_ACTIVE_LOW>;
                        default-state = "off";
@@ -826,10 +826,10 @@ spi10_cs_pins: &spi10_cs_gpio1 {};
                uart0 = <&uart0>, "status";
                wifiaddr = <&wifi>, "local-mac-address[";
 
-               act_led_activelow = <&act_led>, "active-low?";
-               act_led_trigger = <&act_led>, "linux,default-trigger";
-               pwr_led_activelow = <&pwr_led>, "gpios:8";
-               pwr_led_trigger = <&pwr_led>, "linux,default-trigger";
+               act_led_activelow = <&led_act>, "active-low?";
+               act_led_trigger = <&led_act>, "linux,default-trigger";
+               pwr_led_activelow = <&led_pwr>, "gpios:8";
+               pwr_led_trigger = <&led_pwr>, "linux,default-trigger";
                eth_led0 = <&phy1>,"led-modes:0";
                eth_led1 = <&phy1>,"led-modes:4";
                drm_fb0_rp1_dsi0 = <&aliases>, "drm-fb0=",&dsi0;