The Intel VT-d driver checks wrong register to report snoop capablility
when using first level page table for GPA to HPA translation. This might
lead the IOMMU driver to say that it supports snooping control, but in
reality, it does not. Fix this by always setting PASID-table-entry.PGSNP
whenever a pasid entry is setting up for GPA to HPA translation so that
the IOMMU driver could report snoop capability as long as it runs in the
scalable mode.
Fixes:
b802d070a52a1 ("iommu/vt-d: Use iova over first level")
Suggested-by: Rajesh Sankaran <rajesh.sankaran@intel.com>
Suggested-by: Kevin Tian <kevin.tian@intel.com>
Suggested-by: Ashok Raj <ashok.raj@intel.com>
Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
Link: https://lore.kernel.org/r/20210330021145.13824-1-baolu.lu@linux.intel.com
Signed-off-by: Joerg Roedel <jroedel@suse.de>
rcu_read_lock();
for_each_active_iommu(iommu, drhd) {
if (iommu != skip) {
- if (!ecap_sc_support(iommu->ecap)) {
+ /*
+ * If the hardware is operating in the scalable mode,
+ * the snooping control is always supported since we
+ * always set PASID-table-entry.PGSNP bit if the domain
+ * is managed outside (UNMANAGED).
+ */
+ if (!sm_supported(iommu) &&
+ !ecap_sc_support(iommu->ecap)) {
ret = 0;
break;
}
flags |= (level == 5) ? PASID_FLAG_FL5LP : 0;
+ if (domain->domain.type == IOMMU_DOMAIN_UNMANAGED)
+ flags |= PASID_FLAG_PAGE_SNOOP;
+
return intel_pasid_setup_first_level(iommu, dev, (pgd_t *)pgd, pasid,
domain->iommu_did[iommu->seq_id],
flags);
}
/*
+ * Setup the Page Snoop (PGSNP) field (Bit 88) of a scalable mode
+ * PASID entry.
+ */
+static inline void
+pasid_set_pgsnp(struct pasid_entry *pe)
+{
+ pasid_set_bits(&pe->val[1], 1ULL << 24, 1ULL << 24);
+}
+
+/*
* Setup the First Level Page table Pointer field (Bit 140~191)
* of a scalable mode PASID entry.
*/
}
}
+ if (flags & PASID_FLAG_PAGE_SNOOP)
+ pasid_set_pgsnp(pte);
+
pasid_set_domain_id(pte, did);
pasid_set_address_width(pte, iommu->agaw);
pasid_set_page_snoop(pte, !!ecap_smpwc(iommu->ecap));
pasid_set_fault_enable(pte);
pasid_set_page_snoop(pte, !!ecap_smpwc(iommu->ecap));
+ if (domain->domain.type == IOMMU_DOMAIN_UNMANAGED)
+ pasid_set_pgsnp(pte);
+
/*
* Since it is a second level only translation setup, we should
* set SRE bit as well (addresses are expected to be GPAs).
*/
#define PASID_FLAG_SUPERVISOR_MODE BIT(0)
#define PASID_FLAG_NESTED BIT(1)
+#define PASID_FLAG_PAGE_SNOOP BIT(2)
/*
* The PASID_FLAG_FL5LP flag Indicates using 5-level paging for first-