ARM: dts: bcm2712-rpi-5-b: Add act_led_gpio

The Pi 5 DTB was lacking the act_led_gpio parameter, and
act_led_activelow as implemented the old way. Fix both.

See: https://forums.raspberrypi.com/viewtopic.php?t=364719

Signed-off-by: Phil Elwell <phil@raspberrypi.com>

diff --git a/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts b/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
index 83fbfadcdba8f2a995e49b256e99473440414f59..1a4a0e55ea369cc8bc20311b0006d36c8f60d70d 100644 (file)
--- a/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
+++ b/arch/arm/boot/dts/broadcom/bcm2712-rpi-5-b.dts
@@ -824,8 +824,10 @@ spi10_cs_pins: &spi10_cs_gpio1 {};
                uart0 = <&uart0>, "status";
                wifiaddr = <&wifi>, "local-mac-address[";
 
-               act_led_activelow = <&led_act>, "active-low?";
+               act_led_gpio = <&led_act>,"gpios:4",<&led_act>,"gpios:0=",<&gpio>;
+               act_led_activelow = <&led_act>,"gpios:8";
                act_led_trigger = <&led_act>, "linux,default-trigger";
+               pwr_led_gpio = <&led_pwr>,"gpios:4";
                pwr_led_activelow = <&led_pwr>, "gpios:8";
                pwr_led_trigger = <&led_pwr>, "linux,default-trigger";
                eth_led0 = <&phy1>,"led-modes:0";