return HRTIMER_NORESTART;
}
-static const struct serial_rs485 imx_no_rs485 = {}; /* No RS485 if no RTS */
static const struct serial_rs485 imx_rs485_supported = {
.flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND |
SER_RS485_RX_DURING_TX,
/* RTS is required to control the RS485 transmitter */
if (sport->have_rtscts || sport->have_rtsgpio)
sport->port.rs485_supported = imx_rs485_supported;
- else
- sport->port.rs485_supported = imx_no_rs485;
sport->port.flags = UPF_BOOT_AUTOCONF;
timer_setup(&sport->timer, imx_uart_timeout, 0);
return ret;
}
- if (sport->port.rs485.flags & SER_RS485_ENABLED &&
- (!sport->have_rtscts && !sport->have_rtsgpio))
- dev_err(&pdev->dev, "no RTS control, disabling rs485\n");
-
/*
* If using the i.MX UART RTS/CTS control then the RTS (CTS_B)
* signal cannot be set low during transmission in case the
int ret;
int rx_during_tx_gpio_flag;
+ if (!(port->rs485_supported.flags & SER_RS485_ENABLED))
+ return 0;
+
ret = device_property_read_u32_array(dev, "rs485-rts-delay",
rs485_delay, 2);
if (!ret) {