mtd: nand: add NAND_BUSWIDTH_AUTO to autodetect bus width

The driver call nand_scan_ident in 8 bit mode, then
readid or onfi detection are done (and detect bus width).
The driver should update its bus width before calling nand_scan_tail.

This work because readid and onfi are read work 8 byte mode.

Note that nand_scan_ident send command (NAND_CMD_RESET, NAND_CMD_READID, NAND_CMD_PARAM), address and read data
The ONFI specificication is not very clear for x16 device if high byte of address should be driven to 0,
but according to [1] it should be ok to not drive it during autodetection.

[1]
3.3.2. Target Initialization

[...]
The Read ID and Read Parameter Page commands only use the lower 8-bits of the data bus.
The host shall not issue commands that use a word data width on x16 devices until the host
determines the device supports a 16-bit data bus width in the parameter page.

Signed-off-by: Matthieu CASTET <matthieu.castet@parrot.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>

diff --git a/drivers/mtd/nand/nand_base.c b/drivers/mtd/nand/nand_base.c
index 6f58e16..5851c51 100644 (file)
--- a/drivers/mtd/nand/nand_base.c
+++ b/drivers/mtd/nand/nand_base.c
@@ -3250,11 +3250,15 @@ ident_done:
                        break;
        }
 
-       /*
-        * Check, if buswidth is correct. Hardware drivers should set
-        * chip correct!
-        */
-       if (busw != (chip->options & NAND_BUSWIDTH_16)) {
+       if (chip->options & NAND_BUSWIDTH_AUTO) {
+               WARN_ON(chip->options & NAND_BUSWIDTH_16);
+               chip->options |= busw;
+               nand_set_defaults(chip, busw);
+       } else if (busw != (chip->options & NAND_BUSWIDTH_16)) {
+               /*
+                * Check, if buswidth is correct. Hardware drivers should set
+                * chip correct!
+                */
                pr_info("NAND device: Manufacturer ID:"
                        " 0x%02x, Chip ID: 0x%02x (%s %s)\n", *maf_id,
                        *dev_id, nand_manuf_ids[maf_idx].name, mtd->name);

diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h
index 9d8a604..7ccb3c5 100644 (file)
--- a/include/linux/mtd/nand.h
+++ b/include/linux/mtd/nand.h
@@ -219,6 +219,13 @@ typedef enum {
 #define NAND_OWN_BUFFERS       0x00020000
 /* Chip may not exist, so silence any errors in scan */
 #define NAND_SCAN_SILENT_NODEV 0x00040000
+/*
+ * Autodetect nand buswidth with readid/onfi.
+ * This suppose the driver will configure the hardware in 8 bits mode
+ * when calling nand_scan_ident, and update its configuration
+ * before calling nand_scan_tail.
+ */
+#define NAND_BUSWIDTH_AUTO      0x00080000
 
 /* Options set by nand scan */
 /* Nand scan has allocated controller struct */