drivers: qcom: rpmh: cache sleep/wake state requests
authorLina Iyer <ilina@codeaurora.org>
Wed, 20 Jun 2018 13:27:04 +0000 (18:57 +0530)
committerAndy Gross <andy.gross@linaro.org>
Sat, 21 Jul 2018 18:33:12 +0000 (13:33 -0500)
Active state requests are sent immediately to the RSC controller, while
sleep and wake state requests are cached in this driver to avoid taxing
the RSC controller repeatedly. The cached values will be sent to the
controller when the rpmh_flush() is called.

Generally, flushing is a system PM activity and may be called from the
system PM drivers when the system is entering suspend or deeper sleep
modes during cpuidle.

Also allow invalidating the cached requests, so they may be re-populated
again.

Signed-off-by: Lina Iyer <ilina@codeaurora.org>
[rplsssn: remove unneeded semicolon, address line over 80chars error]
Signed-off-by: Raju P.L.S.S.S.N <rplsssn@codeaurora.org>
Reviewed-by: Evan Green <evgreen@chromium.org>
Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>
drivers/soc/qcom/rpmh-internal.h
drivers/soc/qcom/rpmh-rsc.c
drivers/soc/qcom/rpmh.c
include/soc/qcom/rpmh.h

index af4da1c..101145c 100644 (file)
@@ -66,10 +66,14 @@ struct rpmh_request {
 /**
  * struct rpmh_ctrlr: our representation of the controller
  *
- * @drv: the controller instance
+ * @cache: the list of cached requests
+ * @cache_lock: synchronize access to the cache data
+ * @dirty: was the cache updated since flush
  */
 struct rpmh_ctrlr {
-       struct rsc_drv *drv;
+       struct list_head cache;
+       spinlock_t cache_lock;
+       bool dirty;
 };
 
 /**
index fed8459..5d0dd05 100644 (file)
@@ -634,6 +634,9 @@ static int rpmh_rsc_probe(struct platform_device *pdev)
        /* Enable the active TCS to send requests immediately */
        write_tcs_reg(drv, RSC_DRV_IRQ_ENABLE, 0, drv->tcs[ACTIVE_TCS].mask);
 
+       spin_lock_init(&drv->client.cache_lock);
+       INIT_LIST_HEAD(&drv->client.cache);
+
        dev_set_drvdata(&pdev->dev, drv);
 
        return devm_of_platform_populate(&pdev->dev);
index 5e022cb..c355ba1 100644 (file)
@@ -8,10 +8,12 @@
 #include <linux/interrupt.h>
 #include <linux/jiffies.h>
 #include <linux/kernel.h>
+#include <linux/list.h>
 #include <linux/module.h>
 #include <linux/of.h>
 #include <linux/platform_device.h>
 #include <linux/slab.h>
+#include <linux/spinlock.h>
 #include <linux/types.h>
 #include <linux/wait.h>
 
 
 #define ctrlr_to_drv(ctrlr) container_of(ctrlr, struct rsc_drv, client)
 
+/**
+ * struct cache_req: the request object for caching
+ *
+ * @addr: the address of the resource
+ * @sleep_val: the sleep vote
+ * @wake_val: the wake vote
+ * @list: linked list obj
+ */
+struct cache_req {
+       u32 addr;
+       u32 sleep_val;
+       u32 wake_val;
+       struct list_head list;
+};
+
 static struct rpmh_ctrlr *get_rpmh_ctrlr(const struct device *dev)
 {
        struct rsc_drv *drv = dev_get_drvdata(dev->parent);
@@ -60,26 +77,107 @@ void rpmh_tx_done(const struct tcs_request *msg, int r)
                complete(compl);
 }
 
+static struct cache_req *__find_req(struct rpmh_ctrlr *ctrlr, u32 addr)
+{
+       struct cache_req *p, *req = NULL;
+
+       list_for_each_entry(p, &ctrlr->cache, list) {
+               if (p->addr == addr) {
+                       req = p;
+                       break;
+               }
+       }
+
+       return req;
+}
+
+static struct cache_req *cache_rpm_request(struct rpmh_ctrlr *ctrlr,
+                                          enum rpmh_state state,
+                                          struct tcs_cmd *cmd)
+{
+       struct cache_req *req;
+       unsigned long flags;
+
+       spin_lock_irqsave(&ctrlr->cache_lock, flags);
+       req = __find_req(ctrlr, cmd->addr);
+       if (req)
+               goto existing;
+
+       req = kzalloc(sizeof(*req), GFP_ATOMIC);
+       if (!req) {
+               req = ERR_PTR(-ENOMEM);
+               goto unlock;
+       }
+
+       req->addr = cmd->addr;
+       req->sleep_val = req->wake_val = UINT_MAX;
+       INIT_LIST_HEAD(&req->list);
+       list_add_tail(&req->list, &ctrlr->cache);
+
+existing:
+       switch (state) {
+       case RPMH_ACTIVE_ONLY_STATE:
+               if (req->sleep_val != UINT_MAX)
+                       req->wake_val = cmd->data;
+               break;
+       case RPMH_WAKE_ONLY_STATE:
+               req->wake_val = cmd->data;
+               break;
+       case RPMH_SLEEP_STATE:
+               req->sleep_val = cmd->data;
+               break;
+       default:
+               break;
+       }
+
+       ctrlr->dirty = true;
+unlock:
+       spin_unlock_irqrestore(&ctrlr->cache_lock, flags);
+
+       return req;
+}
+
 /**
- * __rpmh_write: send the RPMH request
+ * __rpmh_write: Cache and send the RPMH request
  *
  * @dev: The device making the request
  * @state: Active/Sleep request type
  * @rpm_msg: The data that needs to be sent (cmds).
+ *
+ * Cache the RPMH request and send if the state is ACTIVE_ONLY.
+ * SLEEP/WAKE_ONLY requests are not sent to the controller at
+ * this time. Use rpmh_flush() to send them to the controller.
  */
 static int __rpmh_write(const struct device *dev, enum rpmh_state state,
                        struct rpmh_request *rpm_msg)
 {
        struct rpmh_ctrlr *ctrlr = get_rpmh_ctrlr(dev);
+       int ret = -EINVAL;
+       struct cache_req *req;
+       int i;
 
        rpm_msg->msg.state = state;
 
-       if (state != RPMH_ACTIVE_ONLY_STATE)
-               return -EINVAL;
+       /* Cache the request in our store and link the payload */
+       for (i = 0; i < rpm_msg->msg.num_cmds; i++) {
+               req = cache_rpm_request(ctrlr, state, &rpm_msg->msg.cmds[i]);
+               if (IS_ERR(req))
+                       return PTR_ERR(req);
+       }
+
+       rpm_msg->msg.state = state;
 
-       WARN_ON(irqs_disabled());
+       if (state == RPMH_ACTIVE_ONLY_STATE) {
+               WARN_ON(irqs_disabled());
+               ret = rpmh_rsc_send_data(ctrlr_to_drv(ctrlr), &rpm_msg->msg);
+       } else {
+               ret = rpmh_rsc_write_ctrl_data(ctrlr_to_drv(ctrlr),
+                               &rpm_msg->msg);
+               /* Clean up our call by spoofing tx_done */
+               rpmh_tx_done(&rpm_msg->msg, ret);
+       }
 
-       return rpmh_rsc_send_data(ctrlr_to_drv(ctrlr), &rpm_msg->msg);
+       return ret;
 }
 
 /**
@@ -114,3 +212,96 @@ int rpmh_write(const struct device *dev, enum rpmh_state state,
        return (ret > 0) ? 0 : -ETIMEDOUT;
 }
 EXPORT_SYMBOL(rpmh_write);
+
+static int is_req_valid(struct cache_req *req)
+{
+       return (req->sleep_val != UINT_MAX &&
+               req->wake_val != UINT_MAX &&
+               req->sleep_val != req->wake_val);
+}
+
+static int send_single(const struct device *dev, enum rpmh_state state,
+                      u32 addr, u32 data)
+{
+       DEFINE_RPMH_MSG_ONSTACK(dev, state, NULL, rpm_msg);
+       struct rpmh_ctrlr *ctrlr = get_rpmh_ctrlr(dev);
+
+       /* Wake sets are always complete and sleep sets are not */
+       rpm_msg.msg.wait_for_compl = (state == RPMH_WAKE_ONLY_STATE);
+       rpm_msg.cmd[0].addr = addr;
+       rpm_msg.cmd[0].data = data;
+       rpm_msg.msg.num_cmds = 1;
+
+       return rpmh_rsc_write_ctrl_data(ctrlr_to_drv(ctrlr), &rpm_msg.msg);
+}
+
+/**
+ * rpmh_flush: Flushes the buffered active and sleep sets to TCS
+ *
+ * @dev: The device making the request
+ *
+ * Return: -EBUSY if the controller is busy, probably waiting on a response
+ * to a RPMH request sent earlier.
+ *
+ * This function is always called from the sleep code from the last CPU
+ * that is powering down the entire system. Since no other RPMH API would be
+ * executing at this time, it is safe to run lockless.
+ */
+int rpmh_flush(const struct device *dev)
+{
+       struct cache_req *p;
+       struct rpmh_ctrlr *ctrlr = get_rpmh_ctrlr(dev);
+       int ret;
+
+       if (!ctrlr->dirty) {
+               pr_debug("Skipping flush, TCS has latest data.\n");
+               return 0;
+       }
+
+       /*
+        * Nobody else should be calling this function other than system PM,
+        * hence we can run without locks.
+        */
+       list_for_each_entry(p, &ctrlr->cache, list) {
+               if (!is_req_valid(p)) {
+                       pr_debug("%s: skipping RPMH req: a:%#x s:%#x w:%#x",
+                                __func__, p->addr, p->sleep_val, p->wake_val);
+                       continue;
+               }
+               ret = send_single(dev, RPMH_SLEEP_STATE, p->addr, p->sleep_val);
+               if (ret)
+                       return ret;
+               ret = send_single(dev, RPMH_WAKE_ONLY_STATE,
+                                 p->addr, p->wake_val);
+               if (ret)
+                       return ret;
+       }
+
+       ctrlr->dirty = false;
+
+       return 0;
+}
+EXPORT_SYMBOL(rpmh_flush);
+
+/**
+ * rpmh_invalidate: Invalidate all sleep and active sets
+ * sets.
+ *
+ * @dev: The device making the request
+ *
+ * Invalidate the sleep and active values in the TCS blocks.
+ */
+int rpmh_invalidate(const struct device *dev)
+{
+       struct rpmh_ctrlr *ctrlr = get_rpmh_ctrlr(dev);
+       int ret;
+
+       ctrlr->dirty = true;
+
+       do {
+               ret = rpmh_rsc_invalidate(ctrlr_to_drv(ctrlr));
+       } while (ret == -EAGAIN);
+
+       return ret;
+}
+EXPORT_SYMBOL(rpmh_invalidate);
index c1d0f90..42e62a0 100644 (file)
 int rpmh_write(const struct device *dev, enum rpmh_state state,
               const struct tcs_cmd *cmd, u32 n);
 
+int rpmh_flush(const struct device *dev);
+
+int rpmh_invalidate(const struct device *dev);
+
 #else
 
 static inline int rpmh_write(const struct device *dev, enum rpmh_state state,
                             const struct tcs_cmd *cmd, u32 n)
 { return -ENODEV; }
 
+
+static inline int rpmh_flush(const struct device *dev)
+{ return -ENODEV; }
+
+static inline int rpmh_invalidate(const struct device *dev)
+{ return -ENODEV; }
+
 #endif /* CONFIG_QCOM_RPMH */
 
 #endif /* __SOC_QCOM_RPMH_H__ */