* @second_stream: pointer to second stream
* @playback: the number of playback streams opened
* @capture: the number of capture streams opened
- * @asynchronous: 0=synchronous mode, 1=asynchronous mode
* @cpu_dai: the CPU DAI for this device
* @dev_attr: the sysfs device attribute structure
* @stats: SSI statistics
unsigned int irq;
struct snd_pcm_substream *first_stream;
struct snd_pcm_substream *second_stream;
- unsigned int playback;
- unsigned int capture;
- int asynchronous;
unsigned int fifo_depth;
struct snd_soc_dai_driver cpu_dai_drv;
struct device_attribute dev_attr;
struct snd_soc_dai *dai)
{
struct snd_soc_pcm_runtime *rtd = substream->private_data;
- struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(rtd->cpu_dai);
+ struct fsl_ssi_private *ssi_private =
+ snd_soc_dai_get_drvdata(rtd->cpu_dai);
+ int synchronous = ssi_private->cpu_dai_drv.symmetric_rates;
/*
* If this is the first stream opened, then request the IRQ
* and initialize the SSI registers.
*/
- if (!ssi_private->playback && !ssi_private->capture) {
+ if (!ssi_private->first_stream) {
struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
+ ssi_private->first_stream = substream;
+
/*
* Section 16.5 of the MPC8610 reference manual says that the
* SSI needs to be disabled before updating the registers we set
clrsetbits_be32(&ssi->scr,
CCSR_SSI_SCR_I2S_MODE_MASK | CCSR_SSI_SCR_SYN,
CCSR_SSI_SCR_TFR_CLK_DIS | CCSR_SSI_SCR_I2S_MODE_SLAVE
- | (ssi_private->asynchronous ? 0 : CCSR_SSI_SCR_SYN));
+ | (synchronous ? CCSR_SSI_SCR_SYN : 0));
out_be32(&ssi->stcr,
CCSR_SSI_STCR_TXBIT0 | CCSR_SSI_STCR_TFEN0 |
* master.
*/
- /* 4. Enable the interrupts and DMA requests */
+ /* Enable the interrupts and DMA requests */
out_be32(&ssi->sier, SIER_FLAGS);
/*
* this is bad is because at this point, the PCM driver has not
* finished initializing the DMA controller.
*/
- }
-
- if (!ssi_private->first_stream)
- ssi_private->first_stream = substream;
- else {
- /* This is the second stream open, so we need to impose sample
- * rate and maybe sample size constraints. Note that this can
- * cause a race condition if the second stream is opened before
- * the first stream is fully initialized.
- *
- * We provide some protection by checking to make sure the first
- * stream is initialized, but it's not perfect. ALSA sometimes
- * re-initializes the driver with a different sample rate or
- * size. If the second stream is opened before the first stream
- * has received its final parameters, then the second stream may
- * be constrained to the wrong sample rate or size.
- *
- * FIXME: This code does not handle opening and closing streams
- * repeatedly. If you open two streams and then close the first
- * one, you may not be able to open another stream until you
- * close the second one as well.
- */
- struct snd_pcm_runtime *first_runtime =
- ssi_private->first_stream->runtime;
-
- if (!first_runtime->sample_bits) {
- dev_err(substream->pcm->card->dev,
- "set sample size in %s stream first\n",
- substream->stream == SNDRV_PCM_STREAM_PLAYBACK
- ? "capture" : "playback");
- return -EAGAIN;
- }
+ } else {
+ if (synchronous) {
+ struct snd_pcm_runtime *first_runtime =
+ ssi_private->first_stream->runtime;
+ /*
+ * This is the second stream open, and we're in
+ * synchronous mode, so we need to impose sample
+ * sample size constraints. This is because STCCR is
+ * used for playback and capture in synchronous mode,
+ * so there's no way to specify different word
+ * lengths.
+ *
+ * Note that this can cause a race condition if the
+ * second stream is opened before the first stream is
+ * fully initialized. We provide some protection by
+ * checking to make sure the first stream is
+ * initialized, but it's not perfect. ALSA sometimes
+ * re-initializes the driver with a different sample
+ * rate or size. If the second stream is opened
+ * before the first stream has received its final
+ * parameters, then the second stream may be
+ * constrained to the wrong sample rate or size.
+ */
+ if (!first_runtime->sample_bits) {
+ dev_err(substream->pcm->card->dev,
+ "set sample size in %s stream first\n",
+ substream->stream ==
+ SNDRV_PCM_STREAM_PLAYBACK
+ ? "capture" : "playback");
+ return -EAGAIN;
+ }
- /* If we're in synchronous mode, then we need to constrain
- * the sample size as well. We don't support independent sample
- * rates in asynchronous mode.
- */
- if (!ssi_private->asynchronous)
snd_pcm_hw_constraint_minmax(substream->runtime,
SNDRV_PCM_HW_PARAM_SAMPLE_BITS,
first_runtime->sample_bits,
first_runtime->sample_bits);
+ }
ssi_private->second_stream = substream;
}
- if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK)
- ssi_private->playback++;
-
- if (substream->stream == SNDRV_PCM_STREAM_CAPTURE)
- ssi_private->capture++;
-
return 0;
}
struct snd_pcm_hw_params *hw_params, struct snd_soc_dai *cpu_dai)
{
struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(cpu_dai);
+ struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
+ unsigned int sample_size =
+ snd_pcm_format_width(params_format(hw_params));
+ u32 wl = CCSR_SSI_SxCCR_WL(sample_size);
+ int enabled = in_be32(&ssi->scr) & CCSR_SSI_SCR_SSIEN;
- if (substream == ssi_private->first_stream) {
- struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
- unsigned int sample_size =
- snd_pcm_format_width(params_format(hw_params));
- u32 wl = CCSR_SSI_SxCCR_WL(sample_size);
+ /*
+ * If we're in synchronous mode, and the SSI is already enabled,
+ * then STCCR is already set properly.
+ */
+ if (enabled && ssi_private->cpu_dai_drv.symmetric_rates)
+ return 0;
- /* The SSI should always be disabled at this points (SSIEN=0) */
+ /*
+ * FIXME: The documentation says that SxCCR[WL] should not be
+ * modified while the SSI is enabled. The only time this can
+ * happen is if we're trying to do simultaneous playback and
+ * capture in asynchronous mode. Unfortunately, I have been enable
+ * to get that to work at all on the P1022DS. Therefore, we don't
+ * bother to disable/enable the SSI when setting SxCCR[WL], because
+ * the SSI will stop anyway. Maybe one day, this will get fixed.
+ */
- /* In synchronous mode, the SSI uses STCCR for capture */
- if ((substream->stream == SNDRV_PCM_STREAM_PLAYBACK) ||
- !ssi_private->asynchronous)
- clrsetbits_be32(&ssi->stccr,
- CCSR_SSI_SxCCR_WL_MASK, wl);
- else
- clrsetbits_be32(&ssi->srccr,
- CCSR_SSI_SxCCR_WL_MASK, wl);
- }
+ /* In synchronous mode, the SSI uses STCCR for capture */
+ if ((substream->stream == SNDRV_PCM_STREAM_PLAYBACK) ||
+ ssi_private->cpu_dai_drv.symmetric_rates)
+ clrsetbits_be32(&ssi->stccr, CCSR_SSI_SxCCR_WL_MASK, wl);
+ else
+ clrsetbits_be32(&ssi->srccr, CCSR_SSI_SxCCR_WL_MASK, wl);
return 0;
}
switch (cmd) {
case SNDRV_PCM_TRIGGER_START:
- clrbits32(&ssi->scr, CCSR_SSI_SCR_SSIEN);
case SNDRV_PCM_TRIGGER_PAUSE_RELEASE:
if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK)
setbits32(&ssi->scr,
struct snd_soc_pcm_runtime *rtd = substream->private_data;
struct fsl_ssi_private *ssi_private = snd_soc_dai_get_drvdata(rtd->cpu_dai);
- if (substream->stream == SNDRV_PCM_STREAM_PLAYBACK)
- ssi_private->playback--;
-
- if (substream->stream == SNDRV_PCM_STREAM_CAPTURE)
- ssi_private->capture--;
-
if (ssi_private->first_stream == substream)
ssi_private->first_stream = ssi_private->second_stream;
/*
* If this is the last active substream, disable the SSI.
*/
- if (!ssi_private->playback && !ssi_private->capture) {
+ if (!ssi_private->first_stream) {
struct ccsr_ssi __iomem *ssi = ssi_private->ssi;
clrbits32(&ssi->scr, CCSR_SSI_SCR_SSIEN);
}
/* Are the RX and the TX clocks locked? */
- if (of_find_property(np, "fsl,ssi-asynchronous", NULL))
- ssi_private->asynchronous = 1;
- else
+ if (!of_find_property(np, "fsl,ssi-asynchronous", NULL))
ssi_private->cpu_dai_drv.symmetric_rates = 1;
/* Determine the FIFO depth. */
projects / platform / kernel / linux-rpi.git / commitdiff