When fixed offset via CONFIG_SYS_MMC_U_BOOT_OFFS is not specified then
expects that U-Boot proper is placed immediately after SPL without any
additional padding.
This allows to generate smaller SPL+U-Boot final binary as it is not
required to specify fixed offset to U-Boot proper at SPL compile time.
In this case offset to U-Boot proper is calculated at SPL compile time in
linker script.
Signed-off-by: Pali Rohár <pali@kernel.org>
Reviewed-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Marek Behún <kabel@kernel.org>
__init_begin = .;
__init_end = .;
_end = .;
+
+#ifndef KEEP_RESET_VECTOR
+#if defined(CONFIG_SD_BOOT) && !defined(CONFIG_SYS_MMC_U_BOOT_OFFS)
+ mmc_u_boot_offs = .;
+#endif
+#endif
+
#ifdef CONFIG_SPL_SKIP_RELOCATE
. = ALIGN(4);
__bss_start = .;
.resetvec IMAGE_TEXT_BASE + RESET_VECTOR_OFFSET : {
KEEP(*(.resetvec))
} = 0xffff
+#if defined(CONFIG_SD_BOOT) && !defined(CONFIG_SYS_MMC_U_BOOT_OFFS)
+ mmc_u_boot_offs = .;
+#endif
#endif
#ifndef CONFIG_SPL_SKIP_RELOCATE
#include <mmc.h>
#include <malloc.h>
+#ifndef CONFIG_SYS_MMC_U_BOOT_OFFS
+extern uchar mmc_u_boot_offs[];
+#endif
+
/*
* The environment variables are written to just after the u-boot image
* on SDCard, so we must read the MBR to get the start address and code
val = *(tmp_buf + blk_off + ESDHC_BOOT_IMAGE_ADDR + i);
offset = (offset << 8) + val;
}
+#ifndef CONFIG_SYS_MMC_U_BOOT_OFFS
+ offset += (ulong)&mmc_u_boot_offs - CONFIG_SPL_TEXT_BASE;
+#else
offset += CONFIG_SYS_MMC_U_BOOT_OFFS;
#endif
+#endif
/*
* Load U-Boot image from mmc into RAM
*/