mtd: rawnand: ams-delta: Move the ECC initialization to ->attach_chip()

The probe function is only supposed to initialize the controller
hardware but not the ECC engine. Indeed, we don't know anything about
the NAND chip(s) at this stage. Let's move the logic initializing the
ECC engine, even pretty simple, to the ->attach_chip() hook which gets
called during nand_scan() routine, after the NAND chip discovery. As
the previously mentioned logic is supposed to parse the DT for us, it
is likely that the chip->ecc.* entries be overwritten. So let's avoid
this by moving these lines to ->attach_chip().

Fixes: d7157ff49a5b ("mtd: rawnand: Use the ECC framework user input parsing bits")
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/20201113123424.32233-4-miquel.raynal@bootlin.com

diff --git a/drivers/mtd/nand/raw/ams-delta.c b/drivers/mtd/nand/raw/ams-delta.c
index d3c5cc5..0c352b3 100644 (file)
--- a/drivers/mtd/nand/raw/ams-delta.c
+++ b/drivers/mtd/nand/raw/ams-delta.c
@@ -215,8 +215,17 @@ static int gpio_nand_setup_interface(struct nand_chip *this, int csline,
        return 0;
 }
 
+static int gpio_nand_attach_chip(struct nand_chip *chip)
+{
+       chip->ecc.engine_type = NAND_ECC_ENGINE_TYPE_SOFT;
+       chip->ecc.algo = NAND_ECC_ALGO_HAMMING;
+
+       return 0;
+}
+
 static const struct nand_controller_ops gpio_nand_ops = {
        .exec_op = gpio_nand_exec_op,
+       .attach_chip = gpio_nand_attach_chip,
        .setup_interface = gpio_nand_setup_interface,
 };
 
@@ -260,9 +269,6 @@ static int gpio_nand_probe(struct platform_device *pdev)
                return err;
        }
 
-       this->ecc.engine_type = NAND_ECC_ENGINE_TYPE_SOFT;
-       this->ecc.algo = NAND_ECC_ALGO_HAMMING;
-
        platform_set_drvdata(pdev, priv);
 
        /* Set chip enabled but write protected */