#define CXL_CAPACITY_MULTIPLIER SZ_256M
/**
+ * struct cxl_endpoint_dvsec_info - Cached DVSEC info
+ * @mem_enabled: cached value of mem_enabled in the DVSEC, PCIE_DEVICE
+ * @ranges: Number of active HDM ranges this device uses.
+ * @dvsec_range: cached attributes of the ranges in the DVSEC, PCIE_DEVICE
+ */
+struct cxl_endpoint_dvsec_info {
+ bool mem_enabled;
+ int ranges;
+ struct range dvsec_range[2];
+};
+
+/**
* struct cxl_dev_state - The driver device state
*
* cxl_dev_state represents the CXL driver/device state. It provides an
* @next_volatile_bytes: volatile capacity change pending device reset
* @next_persistent_bytes: persistent capacity change pending device reset
* @component_reg_phys: register base of component registers
+ * @info: Cached DVSEC information about the device.
* @mbox_send: @dev specific transport for transmitting mailbox commands
*
* See section 8.2.9.5.2 Capacity Configuration and Label Storage for
u64 next_persistent_bytes;
resource_size_t component_reg_phys;
+ struct cxl_endpoint_dvsec_info info;
int (*mbox_send)(struct cxl_dev_state *cxlds, struct cxl_mbox_cmd *cmd);
};
/* CXL 2.0 8.1.3: PCIe DVSEC for CXL Device */
#define CXL_DVSEC_PCIE_DEVICE 0
+#define CXL_DVSEC_CAP_OFFSET 0xA
+#define CXL_DVSEC_MEM_CAPABLE BIT(2)
+#define CXL_DVSEC_HDM_COUNT_MASK GENMASK(5, 4)
+#define CXL_DVSEC_CTRL_OFFSET 0xC
+#define CXL_DVSEC_MEM_ENABLE BIT(2)
+#define CXL_DVSEC_RANGE_SIZE_HIGH(i) (0x18 + (i * 0x10))
+#define CXL_DVSEC_RANGE_SIZE_LOW(i) (0x1C + (i * 0x10))
+#define CXL_DVSEC_MEM_INFO_VALID BIT(0)
+#define CXL_DVSEC_MEM_ACTIVE BIT(1)
+#define CXL_DVSEC_MEM_SIZE_LOW_MASK GENMASK(31, 28)
+#define CXL_DVSEC_RANGE_BASE_HIGH(i) (0x20 + (i * 0x10))
+#define CXL_DVSEC_RANGE_BASE_LOW(i) (0x24 + (i * 0x10))
+#define CXL_DVSEC_MEM_BASE_LOW_MASK GENMASK(31, 28)
/* CXL 2.0 8.1.4: Non-CXL Function Map DVSEC */
#define CXL_DVSEC_FUNCTION_MAP 2
return rc;
}
+static int wait_for_valid(struct cxl_dev_state *cxlds)
+{
+ struct pci_dev *pdev = to_pci_dev(cxlds->dev);
+ int d = cxlds->cxl_dvsec, rc;
+ u32 val;
+
+ /*
+ * Memory_Info_Valid: When set, indicates that the CXL Range 1 Size high
+ * and Size Low registers are valid. Must be set within 1 second of
+ * deassertion of reset to CXL device. Likely it is already set by the
+ * time this runs, but otherwise give a 1.5 second timeout in case of
+ * clock skew.
+ */
+ rc = pci_read_config_dword(pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(0), &val);
+ if (rc)
+ return rc;
+
+ if (val & CXL_DVSEC_MEM_INFO_VALID)
+ return 0;
+
+ msleep(1500);
+
+ rc = pci_read_config_dword(pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(0), &val);
+ if (rc)
+ return rc;
+
+ if (val & CXL_DVSEC_MEM_INFO_VALID)
+ return 0;
+
+ return -ETIMEDOUT;
+}
+
+static int cxl_dvsec_ranges(struct cxl_dev_state *cxlds)
+{
+ struct cxl_endpoint_dvsec_info *info = &cxlds->info;
+ struct pci_dev *pdev = to_pci_dev(cxlds->dev);
+ int d = cxlds->cxl_dvsec;
+ int hdm_count, rc, i;
+ u16 cap, ctrl;
+
+ if (!d)
+ return -ENXIO;
+
+ rc = pci_read_config_word(pdev, d + CXL_DVSEC_CAP_OFFSET, &cap);
+ if (rc)
+ return rc;
+
+ rc = pci_read_config_word(pdev, d + CXL_DVSEC_CTRL_OFFSET, &ctrl);
+ if (rc)
+ return rc;
+
+ if (!(cap & CXL_DVSEC_MEM_CAPABLE))
+ return -ENXIO;
+
+ /*
+ * It is not allowed by spec for MEM.capable to be set and have 0 legacy
+ * HDM decoders (values > 2 are also undefined as of CXL 2.0). As this
+ * driver is for a spec defined class code which must be CXL.mem
+ * capable, there is no point in continuing to enable CXL.mem.
+ */
+ hdm_count = FIELD_GET(CXL_DVSEC_HDM_COUNT_MASK, cap);
+ if (!hdm_count || hdm_count > 2)
+ return -EINVAL;
+
+ rc = wait_for_valid(cxlds);
+ if (rc)
+ return rc;
+
+ info->mem_enabled = FIELD_GET(CXL_DVSEC_MEM_ENABLE, ctrl);
+
+ for (i = 0; i < hdm_count; i++) {
+ u64 base, size;
+ u32 temp;
+
+ rc = pci_read_config_dword(
+ pdev, d + CXL_DVSEC_RANGE_SIZE_HIGH(i), &temp);
+ if (rc)
+ return rc;
+
+ size = (u64)temp << 32;
+
+ rc = pci_read_config_dword(
+ pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(i), &temp);
+ if (rc)
+ return rc;
+
+ size |= temp & CXL_DVSEC_MEM_SIZE_LOW_MASK;
+
+ rc = pci_read_config_dword(
+ pdev, d + CXL_DVSEC_RANGE_BASE_HIGH(i), &temp);
+ if (rc)
+ return rc;
+
+ base = (u64)temp << 32;
+
+ rc = pci_read_config_dword(
+ pdev, d + CXL_DVSEC_RANGE_BASE_LOW(i), &temp);
+ if (rc)
+ return rc;
+
+ base |= temp & CXL_DVSEC_MEM_BASE_LOW_MASK;
+
+ info->dvsec_range[i] = (struct range) {
+ .start = base,
+ .end = base + size - 1
+ };
+
+ if (size)
+ info->ranges++;
+ }
+
+ return 0;
+}
+
static int cxl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
{
struct cxl_register_map map;
if (rc)
return rc;
+ rc = cxl_dvsec_ranges(cxlds);
+ if (rc)
+ dev_warn(&pdev->dev,
+ "Failed to get DVSEC range information (%d)\n", rc);
+
cxlmd = devm_cxl_add_memdev(cxlds);
if (IS_ERR(cxlmd))
return PTR_ERR(cxlmd);