Fix typos and add the following to the scripts/spelling.txt:
aligment||alignment
I did not touch the "N_BYTE_ALIGMENT" macro in
drivers/net/wireless/realtek/rtlwifi/wifi.h to avoid unpredictable
impact.
I fixed "_aligment_handler" in arch/openrisc/kernel/entry.S because
it is surrounded by #if 0 ... #endif. It is surely safe and I
confirmed "_alignment_handler" is correct.
I also fixed the "controler" I found in the same hunk in
arch/openrisc/kernel/head.S.
Link: http://lkml.kernel.org/r/1481573103-11329-8-git-send-email-yamada.masahiro@socionext.com
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
++ptr;
}
if (cie != NULL) {
- /* get code aligment factor */
+ /* get code alignment factor */
state.codeAlign = get_uleb128(&ptr, end);
- /* get data aligment factor */
+ /* get data alignment factor */
state.dataAlign = get_sleb128(&ptr, end);
if (state.codeAlign == 0 || state.dataAlign == 0 || ptr >= end)
cie = NULL;
l.j _ret_from_intr
l.nop
-/* ---[ 0x600: Aligment exception ]-------------------------------------- */
+/* ---[ 0x600: Alignment exception ]-------------------------------------- */
EXCEPTION_ENTRY(_alignment_handler)
CLEAR_LWA_FLAG(r3)
l.nop
#if 0
-EXCEPTION_ENTRY(_aligment_handler)
+EXCEPTION_ENTRY(_alignment_handler)
// l.mfspr r2,r0,SPR_EEAR_BASE /* Load the efective addres */
l.addi r2,r4,0
// l.mfspr r5,r0,SPR_EPCR_BASE /* Load the insn address */
.org 0x500
EXCEPTION_HANDLE(_timer_handler)
-/* ---[ 0x600: Aligment exception ]-------------------------------------- */
+/* ---[ 0x600: Alignment exception ]-------------------------------------- */
.org 0x600
EXCEPTION_HANDLE(_alignment_handler)
/* ========================================[ cache ]=== */
- /* aligment here so we don't change memory offsets with
- * memory controler defined
+ /* alignment here so we don't change memory offsets with
+ * memory controller defined
*/
.align 0x2000
/* TODO
* - clean up __offset & stuff
- * - change all 8192 aligment to PAGE !!!
- * - recheck if all aligments are really needed
+ * - change all 8192 alignment to PAGE !!!
+ * - recheck if all alignments are really needed
*/
# define LOAD_OFFSET PAGE_OFFSET
#define HW_ASSISTED_I2C_STATUS_FAILURE 2
#define HW_ASSISTED_I2C_STATUS_SUCCESS 1
-#pragma pack(1) // BIOS data must use byte aligment
+#pragma pack(1) // BIOS data must use byte alignment
// Define offset to location of ROM header.
#define OFFSET_TO_POINTER_TO_ATOM_ROM_HEADER 0x00000048L
/*********************************************************************************/
-#pragma pack() // BIOS data must use byte aligment
+#pragma pack() // BIOS data must use byte alignment
#pragma pack(1)
-#pragma pack() // BIOS data must use byte aligment
+#pragma pack() // BIOS data must use byte alignment
//
// AMD ACPI Table
* this is sufficient as the null state generator makes the final batch
* with two passes to build command and state separately. At this point
* the size of both are known and it compacts them by relocating the state
- * right after the commands taking care of aligment so we should sufficient
+ * right after the commands taking care of alignment so we should sufficient
* space below them for adding new commands.
*/
#define OUT_BATCH(batch, i, val) \
#define HW_ASSISTED_I2C_STATUS_FAILURE 2
#define HW_ASSISTED_I2C_STATUS_SUCCESS 1
-#pragma pack(1) /* BIOS data must use byte aligment */
+#pragma pack(1) /* BIOS data must use byte alignment */
/* Define offset to location of ROM header. */
/*********************************************************************************/
-#pragma pack() // BIOS data must use byte aligment
+#pragma pack() // BIOS data must use byte alignment
//
// AMD ACPI Table
* @pix_limit: pixel size constraints for the scaler
* @min_inp_pixsize: minimum input pixel size
* @min_out_pixsize: minimum output pixel size
- * @hor_offs_align: horizontal pixel offset aligment
+ * @hor_offs_align: horizontal pixel offset alignment
* @min_vsize_align: minimum vertical pixel size alignment
*/
struct fimc_variant {
/*
* MRC (Maximal Ratio Combining) has always been used with multi-antenna ofdm.
* With OFDM for single stream you just add up all antenna inputs, you're
- * only interested in what you get after FFT. Signal aligment is also not
+ * only interested in what you get after FFT. Signal alignment is also not
* required for OFDM because any phase difference adds up in the frequency
* domain.
*
* MRC requires extra work for use with CCK. You need to align the antenna
* signals from the different antenna before you can add the signals together.
- * You need aligment of signals as CCK is in time domain, so addition can cancel
+ * You need alignment of signals as CCK is in time domain, so addition can cancel
* your signal completely if phase is 180 degrees (think of adding sine waves).
* You also need to remove noise before the addition and this is where ANI
* MRC CCK comes into play. One of the antenna inputs may be stronger but
u8 i = 0;
do {
- /* 8 - Byte aligment */
+ /* 8 - Byte alignment */
len = H2C_TX_CMD_HDR_LEN + N_BYTE_ALIGMENT(pcmd_len[i], 8);
/* Buffer length is not enough */
u8 i = 0;
do {
- /* 8 - Byte aligment */
+ /* 8 - Byte alignment */
len = H2C_TX_CMD_HDR_LEN + N_BYTE_ALIGMENT(pcmd_len[i], 8);
/* Buffer length is not enough */
/*
* SG elements array within the IO request must be double word
- * aligned. This aligment is required to optimize SGM setup for the IO.
+ * aligned. This alignment is required to optimize SGM setup for the IO.
*/
struct bfi_sge_s sges[BFI_SGE_INLINE_MAX];
u8 io_timeout;
COMPAT_XT_ALIGN(target_offset + sizeof(struct compat_xt_standard_target)) != next_offset)
return -EINVAL;
- /* compat_xt_entry match has less strict aligment requirements,
+ /* compat_xt_entry match has less strict alignment requirements,
* otherwise they are identical. In case of padding differences
* we need to add compat version of xt_check_entry_match.
*/
algoritms||algorithms
algorrithm||algorithm
algorritm||algorithm
+aligment||alignment
allign||align
allocatrd||allocated
allocte||allocate
projects / platform / kernel / linux-starfive.git / commitdiff