pin-controller pin's name must be equal to pin's name used in device
tree with "pins" DT property.
Issue detected on stm32mp157c-ev1 board with goodix touchscreen.
In DT, the goodix's pin is declared in DT with the node:
goodix_pins: goodix {
pins = "gpio14";
bias-pull-down;
};
Whereas in stmfx pin-controller driver, pin's name are equal to
"stmfx_gpioxx" where xx is the pin number.
This lead to not configure stmfx's pins at probe because pins is
identified by its name (see pinctrl_pin_name_to_selector() in
pinctrl-generic.c) and stmfx pin "gpio14" can't be found.
To fix this issue, come back to the original stmfx pin's name.
Revert "pinctrl: stmfx: update pin name"
This reverts commit
38d30cdcd65c73eeefac5efa328ad444a53b77dd.
Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
Tested-by: Patrick DELAUNAY <patrick.delaunay@st.com>
Reviewed-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
}
/*
- * STMFX pins[15:0] are called "stmfx_gpio[15:0]"
- * and STMFX pins[23:16] are called "stmfx_agpio[7:0]"
+ * STMFX pins[15:0] are called "gpio[15:0]"
+ * and STMFX pins[23:16] are called "agpio[7:0]"
*/
#define MAX_PIN_NAME_LEN 7
static char pin_name[MAX_PIN_NAME_LEN];
unsigned int selector)
{
if (selector < STMFX_MAX_GPIO)
- snprintf(pin_name, MAX_PIN_NAME_LEN, "stmfx_gpio%u", selector);
+ snprintf(pin_name, MAX_PIN_NAME_LEN, "gpio%u", selector);
else
- snprintf(pin_name, MAX_PIN_NAME_LEN, "stmfx_agpio%u", selector - 16);
+ snprintf(pin_name, MAX_PIN_NAME_LEN, "agpio%u", selector - 16);
return pin_name;
}