ARM: dts: stm32: add PWM pins used on stm32mp157c-ev1 board

stm32mp157c evaluation board has following PWM pins available on GPIO
expansion connector:
- TIM2_CH4 (PA3)
- TIM8_CH4 (PI2)
- TIM12_CH1 (PH6)

Signed-off-by: Fabrice Gasnier <fabrice.gasnier@st.com>
Signed-off-by: Alexandre Torgue <alexandre.torgue@st.com>

diff --git a/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi b/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
index 6f0441003de03909b75cfd380d557eaac0adac2d..5ee5b3bcfe33eb6177a99783f55d392a479ecab9 100644 (file)
--- a/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
@@ -146,6 +146,33 @@
                                gpio-ranges = <&pinctrl 0 160 8>;
                        };
 
+                       pwm2_pins_a: pwm2-0 {
+                               pins {
+                                       pinmux = <STM32_PINMUX('A', 3, AF1)>; /* TIM2_CH4 */
+                                       bias-pull-down;
+                                       drive-push-pull;
+                                       slew-rate = <0>;
+                               };
+                       };
+
+                       pwm8_pins_a: pwm8-0 {
+                               pins {
+                                       pinmux = <STM32_PINMUX('I', 2, AF3)>; /* TIM8_CH4 */
+                                       bias-pull-down;
+                                       drive-push-pull;
+                                       slew-rate = <0>;
+                               };
+                       };
+
+                       pwm12_pins_a: pwm12-0 {
+                               pins {
+                                       pinmux = <STM32_PINMUX('H', 6, AF2)>; /* TIM12_CH1 */
+                                       bias-pull-down;
+                                       drive-push-pull;
+                                       slew-rate = <0>;
+                               };
+                       };
+
                        uart4_pins_a: uart4@0 {
                                pins1 {
                                        pinmux = <STM32_PINMUX('G', 11, AF6)>; /* UART4_TX */