hpsa: always call pci_set_master after pci_enable_device
authorRobert Elliott <elliott@hp.com>
Fri, 14 Nov 2014 23:27:24 +0000 (17:27 -0600)
committerChristoph Hellwig <hch@lst.de>
Thu, 20 Nov 2014 08:11:27 +0000 (09:11 +0100)
If the kernel is booted with the reset_device parameter, which
is done for kdump, then the driver needs to call pci_set_master
after pci_enable_device to reenable bus mastering (since
the preceding pci_disable_device call disables bus mastering).

Also, place that after pci_request_regions both in the
kdump code and the normal pci_init code.

Remove the comment summarizing what pci_set_master
does, with the incomplete commentary on the impact of
pci_disable_device.

Signed-off-by: Robert Elliott <elliott@hp.com>
Signed-off-by: Don Brace <don.brace@pmcs.com>
Reviewed-by: Don Brace <don.brace@pmcs.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>
drivers/scsi/hpsa.c

index 4db9d19..36db63f 100644 (file)
@@ -6363,15 +6363,15 @@ static int hpsa_pci_init(struct ctlr_info *h)
                return err;
        }
 
-       /* Enable bus mastering (pci_disable_device may disable this) */
-       pci_set_master(h->pdev);
-
        err = pci_request_regions(h->pdev, HPSA);
        if (err) {
                dev_err(&h->pdev->dev,
                        "cannot obtain PCI resources, aborting\n");
                return err;
        }
+
+       pci_set_master(h->pdev);
+
        hpsa_interrupt_mode(h);
        err = hpsa_pci_find_memory_BAR(h->pdev, &h->paddr);
        if (err)
@@ -6451,7 +6451,9 @@ static int hpsa_init_reset_devices(struct pci_dev *pdev)
                dev_warn(&pdev->dev, "failed to enable device.\n");
                return -ENODEV;
        }
+
        pci_set_master(pdev);
+
        /* Reset the controller with a PCI power-cycle or via doorbell */
        rc = hpsa_kdump_hard_reset_controller(pdev);