/*
** Determine if this is a "mibget" or a "mibset". If this is a
** "mibget", then make sure that the MIB may be read. Otherwise,
- ** this is a "mibset" so make make sure that the MIB may be written.
+ ** this is a "mibset" so make sure that the MIB may be written.
*/
isget = (msg->msgcode == DIDMSG_DOT11REQ_MIBGET);
case WLAN_MSD_FWLOAD:
wlandev->msdstate = WLAN_MSD_RUNNING_PENDING;
/* Initialize the device+driver for full
- * operation. Note that this might me an FWLOAD to
+ * operation. Note that this might me an FWLOAD
* to RUNNING transition so we must not do a chip
* or board level reset. Note that on failure,
* the MSD state is set to HWPRESENT because we
* we get back in range. We should block transmits and
* receives in this state. Do we need an indication here?
* Probably not since a polling user-mode element would
- * get this status from from p2PortStatus(FD40). What about
+ * get this status from p2PortStatus(FD40). What about
* p80211?
* Response:
* Block Transmits, Ignore receives of data frames