ARM: dts: at91-sama5d4: use IRQ_TYPE_* to specify irq flags

According to the binding documentation and the source code the atmel-gpio
controller takes IRQ_TYPE_* as its flags values, not GPIO_ACTIVE_*.

This patch uses the right variable type which yields the same result
when compiled. Note that this might be wrong and actually
IRQ_TYPE_LEVEL_LOW is intended by the dt author.

Signed-off-by: Uwe Kleine-König <uwe@kleine-koenig.org>
Acked-by: Marek Vasut <marex@denx.de>
Signed-off-by: Alexandre Belloni <alexandre.belloni@free-electrons.com>

diff --git a/arch/arm/boot/dts/at91-sama5d4_ma5d4.dtsi b/arch/arm/boot/dts/at91-sama5d4_ma5d4.dtsi
index b5a5a91..b813fdf 100644 (file)
--- a/arch/arm/boot/dts/at91-sama5d4_ma5d4.dtsi
+++ b/arch/arm/boot/dts/at91-sama5d4_ma5d4.dtsi
@@ -75,7 +75,7 @@
                                        reg = <0>;
                                        clocks = <&clk20m>;
                                        interrupt-parent = <&pioE>;
-                                       interrupts = <6 GPIO_ACTIVE_LOW>;
+                                       interrupts = <6 IRQ_TYPE_EDGE_RISING>;
                                        spi-max-frequency = <10000000>;
                                };
 
@@ -84,7 +84,7 @@
                                        reg = <1>;
                                        clocks = <&clk20m>;
                                        interrupt-parent = <&pioE>;
-                                       interrupts = <7 GPIO_ACTIVE_LOW>;
+                                       interrupts = <7 IRQ_TYPE_EDGE_RISING>;
                                        spi-max-frequency = <10000000>;
                                };
                        };