gpio: Add generic serializer DT binding
authorAndrew F. Davis <afd@ti.com>
Fri, 4 Mar 2016 18:58:44 +0000 (12:58 -0600)
committerLinus Walleij <linus.walleij@linaro.org>
Tue, 15 Mar 2016 08:54:28 +0000 (09:54 +0100)
Add binding for generic parallel-in/serial-out shift register devices
used as GPIO.

Signed-off-by: Andrew F. Davis <afd@ti.com>
Acked-by: Rob Herring <robh@kernel.org>
[Clarified ngpios semantic]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Documentation/devicetree/bindings/gpio/gpio-pisosr.txt [new file with mode: 0644]

diff --git a/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt b/Documentation/devicetree/bindings/gpio/gpio-pisosr.txt
new file mode 100644 (file)
index 0000000..414a01c
--- /dev/null
@@ -0,0 +1,34 @@
+Generic Parallel-in/Serial-out Shift Register GPIO Driver
+
+This binding describes generic parallel-in/serial-out shift register
+devices that can be used for GPI (General Purpose Input). This includes
+SN74165 serial-out shift registers and the SN65HVS88x series of
+industrial serializers.
+
+Required properties:
+ - compatible          : Should be "pisosr-gpio".
+ - gpio-controller     : Marks the device node as a GPIO controller.
+ - #gpio-cells         : Should be two. For consumer use see gpio.txt.
+
+Optional properties:
+ - ngpios              : Number of used GPIO lines (0..n-1), default is 8.
+ - load-gpios          : GPIO pin specifier attached to load enable, this
+                         pin is pulsed before reading from the device to
+                         load input pin values into the the device.
+
+For other required and optional properties of SPI slave
+nodes please refer to ../spi/spi-bus.txt.
+
+Example:
+
+       gpio@0 {
+               compatible = "ti,sn65hvs882", "pisosr-gpio";
+               gpio-controller;
+               #gpio-cells = <2>;
+
+               load-gpios = <&gpio2 23 GPIO_ACTIVE_LOW>;
+
+               reg = <0>;
+               spi-max-frequency = <1000000>;
+               spi-cpol;
+       };