[PATCH] e1000: Fix Wake-on-Lan with forced gigabit speed

If the user has forced gigabit speed, phy power management must be disabled;
otherwise the NIC would try to negotiate to a linkspeed of 10/100 mbit on
shutdown, which would lead to a total loss of link. This loss of link breaks
Wake-on-Lan and IPMI.

Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com>
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c
index 7a51283..f772e4d 100644 (file)
--- a/drivers/net/e1000/e1000_main.c
+++ b/drivers/net/e1000/e1000_main.c
@@ -732,6 +732,20 @@ e1000_reset(struct e1000_adapter *adapter)
        if (e1000_init_hw(&adapter->hw))
                DPRINTK(PROBE, ERR, "Hardware Error\n");
        e1000_update_mng_vlan(adapter);
+
+       /* if (adapter->hwflags & HWFLAGS_PHY_PWR_BIT) { */
+       if (adapter->hw.mac_type >= e1000_82544 &&
+           adapter->hw.mac_type <= e1000_82547_rev_2 &&
+           adapter->hw.autoneg == 1 &&
+           adapter->hw.autoneg_advertised == ADVERTISE_1000_FULL) {
+               uint32_t ctrl = E1000_READ_REG(&adapter->hw, CTRL);
+               /* clear phy power management bit if we are in gig only mode,
+                * which if enabled will attempt negotiation to 100Mb, which
+                * can cause a loss of link at power off or driver unload */
+               ctrl &= ~E1000_CTRL_SWDPIN3;
+               E1000_WRITE_REG(&adapter->hw, CTRL, ctrl);
+       }
+
        /* Enable h/w to recognize an 802.1Q VLAN Ethernet packet */
        E1000_WRITE_REG(&adapter->hw, VET, ETHERNET_IEEE_VLAN_TYPE);