sunxi: Pine-H64: Explicitly enable PHY regulator
authorAndre Przywara <andre.przywara@arm.com>
Mon, 6 Jul 2020 00:40:46 +0000 (01:40 +0100)
committerJagan Teki <jagan@amarulasolutions.com>
Wed, 21 Oct 2020 18:15:50 +0000 (23:45 +0530)
According to the devicetree and the schematic, the 3.3V power rail for
the PHY is enabled by GPIO PC16. It's wired as active-high, with a
pull-up resistor, so actually works already when the GPIO is in
High-Z state.

However we should not take any chances and explicitly set the GPIO pin
to high, to avoid accidentally losing the PHY power.
The existing MACPWR Kconfig allows to do this easily.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Acked-by: Maxime Ripard <mripard@kernel.org>
Tested-by: Amit Singh Tomar <amittomer25@gmail.com> # Pine64+
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
configs/pine_h64_defconfig

index 328849d..07ad31e 100644 (file)
@@ -11,5 +11,6 @@ CONFIG_SPL_SPI_SUNXI=y
 CONFIG_DEFAULT_DEVICE_TREE="sun50i-h6-pine-h64"
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_SUN8I_EMAC=y
+CONFIG_MACPWR="PC16"
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y