If we make all QSPI (SPI protocol) addressing consistent across all ColdFire
family members then we will be able to remove the duplicated plaform data
and code and use a single setup for all.
So modify the ColdFire 523x QSPI addressing so that:
. base addresses are absolute (not relative to MBAR peripheral register)
. use a common name for IRQs used
. move chip select definitions (CS) to appropriate header
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
#define MCF_IRQ_FECTX0 (MCFINT_VECBASE + MCFINT_FECTX0)
#define MCF_IRQ_FECENTC0 (MCFINT_VECBASE + MCFINT_FECENTC0)
+#define MCF_IRQ_QSPI (MCFINT_VECBASE + MCFINT_QSPI)
+
/*
* SDRAM configuration registers.
*/
#define MCFFEC_SIZE0 0x800
/*
+ * QSPI module.
+ */
+#define MCFQSPI_BASE (MCF_IPSBAR + 0x340)
+#define MCFQSPI_SIZE 0x40
+
+#define MCFQSPI_CS0 91
+#define MCFQSPI_CS1 92
+#define MCFQSPI_CS2 103
+#define MCFQSPI_CS3 99
+
+/*
* GPIO module.
*/
#define MCFGPIO_PODR_ADDR (MCF_IPSBAR + 0x100000)
#ifndef mcfqspi_h
#define mcfqspi_h
-#if defined(CONFIG_M523x) || defined(CONFIG_M527x) || defined(CONFIG_M528x)
+#if defined(CONFIG_M527x) || defined(CONFIG_M528x)
#define MCFQSPI_IOBASE (MCF_IPSBAR + 0x340)
#elif defined(CONFIG_M5249)
#define MCFQSPI_IOBASE (MCF_MBAR + 0x300)
#if defined(CONFIG_SPI_COLDFIRE_QSPI) || defined(CONFIG_SPI_COLDFIRE_QSPI_MODULE)
static struct resource m523x_qspi_resources[] = {
{
- .start = MCFQSPI_IOBASE,
- .end = MCFQSPI_IOBASE + MCFQSPI_IOSIZE - 1,
+ .start = MCFQSPI_BASE,
+ .end = MCFQSPI_BASE + MCFQSPI_SIZE - 1,
.flags = IORESOURCE_MEM,
},
{
- .start = MCFINT_VECBASE + MCFINT_QSPI,
- .end = MCFINT_VECBASE + MCFINT_QSPI,
+ .start = MCF_IRQ_QSPI,
+ .end = MCF_IRQ_QSPI,
.flags = IORESOURCE_IRQ,
},
};
-#define MCFQSPI_CS0 91
-#define MCFQSPI_CS1 92
-#define MCFQSPI_CS2 103
-#define MCFQSPI_CS3 99
-
static int m523x_cs_setup(struct mcfqspi_cs_control *cs_control)
{
int status;