ARM: dts: amlogic: Used onboard usb hub reset to enable usb hub

On Odroid c1 previously use gpio-hog to reset the usb hub,
switch to used on board usb hub reset to enable the usb hub
and enable power to usb hub.

Add usb hub regulator as per the schematic.

Signed-off-by: Anand Moon <linux.amoon@gmail.com>
Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
Link: https://lore.kernel.org/r/20230118044418.875-3-linux.amoon@gmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index 04356bc..d1f9ce4 100644 (file)
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -281,19 +281,6 @@
                          "J7 Header Pin 6", "J7 Header Pin 5",
                          "J7 Header Pin 7", "HDMI_CEC",
                          "SYS_LED", "", "";
-
-       /*
-        * WARNING: The USB Hub on the Odroid-C1/C1+ needs a reset signal
-        * to be turned high in order to be detected by the USB Controller.
-        * This signal should be handled by a USB specific power sequence
-        * in order to reset the Hub when USB bus is powered down.
-        */
-       usb-hub {
-               gpio-hog;
-               gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>;
-               output-high;
-               line-name = "usb-hub-reset";
-       };
 };
 
 &ir_receiver {
@@ -381,5 +368,16 @@
 };
 
 &usb1 {
+       dr_mode = "host";
+       #address-cells = <1>;
+       #size-cells = <0>;
        status = "okay";
+
+       hub@1 {
+               /* Genesys Logic GL852G usb hub */
+               compatible = "usb5e3,610";
+               reg = <1>;
+               vdd-supply = <&p5v0>;
+               reset-gpio = <&gpio_ao GPIOAO_4 GPIO_ACTIVE_LOW>;
+       };
 };