net: macb: Add zynqmp SGMII dynamic configuration support

Add support for the dynamic configuration which takes care of
configuring the GEM secure space configuration registers
using EEMI APIs.
High level sequence is to:
- Check for the PM dynamic configuration support, if no error proceed with
  GEM dynamic configurations(next steps) otherwise skip the dynamic
  configuration.
- Configure GEM Fixed configurations.
- Configure GEM_CLK_CTRL (gemX_sgmii_mode).
- Trigger GEM reset.

Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey@amd.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Tested-by: Conor Dooley <conor.dooley@microchip.com> (for MPFS)
Reviewed-by: Claudiu Beznea <claudiu.beznea@microchip.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

diff --git a/drivers/net/ethernet/cadence/macb_main.c b/drivers/net/ethernet/cadence/macb_main.c
index 66c7d08d376a7ef0c97abf63126cc209b7acefa2..4769c8a0c73a6109ca412e781c018c9625186e4f 100644 (file)
--- a/drivers/net/ethernet/cadence/macb_main.c
+++ b/drivers/net/ethernet/cadence/macb_main.c
@@ -38,6 +38,7 @@
 #include <linux/pm_runtime.h>
 #include <linux/ptp_classify.h>
 #include <linux/reset.h>
+#include <linux/firmware/xlnx-zynqmp.h>
 #include "macb.h"
 
 /* This structure is only used for MACB on SiFive FU540 devices */
@@ -4621,6 +4622,25 @@ static int init_reset_optional(struct platform_device *pdev)
                                             "failed to init SGMII PHY\n");
        }
 
+       ret = zynqmp_pm_is_function_supported(PM_IOCTL, IOCTL_SET_GEM_CONFIG);
+       if (!ret) {
+               u32 pm_info[2];
+
+               ret = of_property_read_u32_array(pdev->dev.of_node, "power-domains",
+                                                pm_info, ARRAY_SIZE(pm_info));
+               if (ret) {
+                       dev_err(&pdev->dev, "Failed to read power management information\n");
+                       goto err_out_phy_exit;
+               }
+               ret = zynqmp_pm_set_gem_config(pm_info[1], GEM_CONFIG_FIXED, 0);
+               if (ret)
+                       goto err_out_phy_exit;
+
+               ret = zynqmp_pm_set_gem_config(pm_info[1], GEM_CONFIG_SGMII_MODE, 1);
+               if (ret)
+                       goto err_out_phy_exit;
+       }
+
        /* Fully reset controller at hardware level if mapped in device tree */
        ret = device_reset_optional(&pdev->dev);
        if (ret) {
@@ -4629,6 +4649,8 @@ static int init_reset_optional(struct platform_device *pdev)
        }
 
        ret = macb_init(pdev);
+
+err_out_phy_exit:
        if (ret)
                phy_exit(bp->sgmii_phy);