tg3: Fix poor tx performance on 57766 after MTU change

GRC reset causes the read DMA engine to go into a mode that breaks up
requests into 256 bytes.  A PHY reset is required to bring it back to
the normal mode.

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 0da93db..a8490a4 100644 (file)
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c
@@ -12267,7 +12267,7 @@ static inline void tg3_set_mtu(struct net_device *dev, struct tg3 *tp,
 static int tg3_change_mtu(struct net_device *dev, int new_mtu)
 {
        struct tg3 *tp = netdev_priv(dev);
-       int err;
+       int err, reset_phy = 0;
 
        if (new_mtu < TG3_MIN_MTU || new_mtu > TG3_MAX_MTU(tp))
                return -EINVAL;
@@ -12290,7 +12290,13 @@ static int tg3_change_mtu(struct net_device *dev, int new_mtu)
 
        tg3_set_mtu(dev, tp, new_mtu);
 
-       err = tg3_restart_hw(tp, 0);
+       /* Reset PHY, otherwise the read DMA engine will be in a mode that
+        * breaks all requests to 256 bytes.
+        */
+       if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_57766)
+               reset_phy = 1;
+
+       err = tg3_restart_hw(tp, reset_phy);
 
        if (!err)
                tg3_netif_start(tp);