serial: mxc: enable the RX pipeline

on imx8(mm) the RXDMUXSEL needs to be set for data going over the wire
(as observable on a connected 'scope) to actually make it into the
RXFIFO

the reference manual is not overly clear about this, and only
mentiones that "UCR3_RXDMUXSEL should always be set." - and since the
CR3 register reverts to its reset values after setting the baudrate,
setting this bit is done during '_mxc_serial_setbgr'

Signed-off-by: Johannes Schneider <johannes.schneider@leica-geosystems.com>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
Reviewed-by: Fabio Estevam <festevam@denx.de>

diff --git a/drivers/serial/serial_mxc.c b/drivers/serial/serial_mxc.c
index 70a0e5e..ee17a96 100644 (file)
--- a/drivers/serial/serial_mxc.c
+++ b/drivers/serial/serial_mxc.c
@@ -61,6 +61,11 @@
 #define UCR3_AWAKEN    (1<<4)  /* Async wake interrupt enable */
 #define UCR3_REF25     (1<<3)  /* Ref freq 25 MHz */
 #define UCR3_REF30     (1<<2)  /* Ref Freq 30 MHz */
+
+/* imx8 names these bitsfields instead: */
+#define UCR3_DTRDEN    BIT(3)  /* bit not used in this chip */
+#define UCR3_RXDMUXSEL BIT(2)  /* RXD muxed input selected; 'should always be set' */
+
 #define UCR3_INVT      (1<<1)  /* Inverted Infrared transmission */
 #define UCR3_BPEN      (1<<0)  /* Preset registers enable */
 #define UCR4_CTSTL_32  (32<<10) /* CTS trigger level (32 chars) */
@@ -176,6 +181,14 @@ static void _mxc_serial_setbrg(struct mxc_uart *base, unsigned long clk,
 
        writel(UCR2_WS | UCR2_IRTS | UCR2_RXEN | UCR2_TXEN | UCR2_SRST,
               &base->cr2);
+
+       /*
+        * setting the baudrate triggers a reset, returning cr3 to its
+        * reset value but UCR3_RXDMUXSEL "should always be set."
+        * according to the imx8 reference-manual
+        */
+       writel(readl(&base->cr3) | UCR3_RXDMUXSEL, &base->cr3);
+
        writel(UCR1_UARTEN, &base->cr1);
 }