[media] cx231xx: fix GPIOs for Pixelview SBTVD hybrid

This device uses GPIOs: 28 to switch between analog and
digital modes: on digital mode, it should be set to 1.

The code that sets it on analog mode is OK, but it misses
the logic that sets it on digital mode.

Cc: stable@vger.kernel.org
Signed-off-by: Mauro Carvalho Chehab <mchehab@s-opensource.com>

diff --git a/drivers/media/usb/cx231xx/cx231xx-cards.c b/drivers/media/usb/cx231xx/cx231xx-cards.c
index c63248a..72c246b 100644 (file)
--- a/drivers/media/usb/cx231xx/cx231xx-cards.c
+++ b/drivers/media/usb/cx231xx/cx231xx-cards.c
@@ -486,7 +486,7 @@ struct cx231xx_board cx231xx_boards[] = {
                .output_mode = OUT_MODE_VIP11,
                .demod_xfer_mode = 0,
                .ctl_pin_status_mask = 0xFFFFFFC4,
-               .agc_analog_digital_select_gpio = 0x00, /* According with PV cxPolaris.inf file */
+               .agc_analog_digital_select_gpio = 0x1c,
                .tuner_sif_gpio = -1,
                .tuner_scl_gpio = -1,
                .tuner_sda_gpio = -1,

diff --git a/drivers/media/usb/cx231xx/cx231xx-core.c b/drivers/media/usb/cx231xx/cx231xx-core.c
index 7e43191..97730cb 100644 (file)
--- a/drivers/media/usb/cx231xx/cx231xx-core.c
+++ b/drivers/media/usb/cx231xx/cx231xx-core.c
@@ -712,6 +712,7 @@ int cx231xx_set_mode(struct cx231xx *dev, enum cx231xx_mode set_mode)
                        break;
                case CX231XX_BOARD_CNXT_RDE_253S:
                case CX231XX_BOARD_CNXT_RDU_253S:
+               case CX231XX_BOARD_PV_PLAYTV_USB_HYBRID:
                        errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 1);
                        break;
                case CX231XX_BOARD_HAUPPAUGE_EXETER:
@@ -738,7 +739,7 @@ int cx231xx_set_mode(struct cx231xx *dev, enum cx231xx_mode set_mode)
                case CX231XX_BOARD_PV_PLAYTV_USB_HYBRID:
                case CX231XX_BOARD_HAUPPAUGE_USB2_FM_PAL:
                case CX231XX_BOARD_HAUPPAUGE_USB2_FM_NTSC:
-               errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 0);
+                       errCode = cx231xx_set_agc_analog_digital_mux_select(dev, 0);
                        break;
                default:
                        break;