Pull in the platform base tree for crossbar support and DRA74x/DRA72x
differentiation support, and for AM57xx Beagle X15 board support. The
iommu interrupts on DRA7 require the crossbar driver for functionality,
as almost all of the interrupts require crossbar programming. DSP2 is
present only on DRA74x SoCs, so the corresponding MMU needs to be
instantiated only on DRA74x SoCs.
* 'platform-ti-linux-3.14.y' of git://git.ti.com/~rrnayak/ti-linux-kernel/platform-linux-feature-tree: (1356 commits)
ARM: dts: Add am57xx-beagle-x15
ARM: OMAP2+: board-generic: add support for AM57xx family
ARM: dts: AM43xx: Add node for RNG
ARM: dts: AM43xx: clk: Add RNG clk node
ARM: AMx3xx: hwmod: Add data for RNG
ARM: AM43xx: hwmod: Add data for DES
ti_config_fragments/baseport.cfg: Enable Crypto hardware acclerators
ARM: dts: DRA7: Add DT node for RNG IP
ARM: dts: DRA7: Add DT node for SHA IP
ARM: dts: DRA7: Add DT node for AES IP
ARM: dts: DRA7: Add DT node for DES IP
ARM: DRA7: hwmod: Add data for RNG IP
ARM: DRA7: hwmod: Add data for SHA IP
ARM: DRA7: hwmod: Add data for AES IP
ARM: DRA7: hwmod: Add data for DES IP
ti_config_fragments/baseport: Enable gpio controlled regulators
ARM: OMAP2+: clock: allow omap2_dpll_round_rate() to round to next-lowest rate
CLK: TI: Enable dss_deshdcp clock in dra7xx_clk_init
ARM: dts: Add dss_deshdcp clock node under dra7-ctrl-core
ARM: dts: Add ctrl-core DT node for DRA7
...
Signed-off-by: Suman Anna <s-anna@ti.com>