savagefb: Set up I2C based on chip family instead of card id

In practice this means enabling I2C (for DDC2) on all prosavage cards,
like the xorg ddx does. The savage4 and savage2000 families have only
one member each, so there is no change for those.

Tested on TwisterK.

Signed-off-by: Tormod Volden <debian.tormod@gmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

diff --git a/drivers/video/savage/savagefb-i2c.c b/drivers/video/savage/savagefb-i2c.c
index 58c8a3c..5e7acda 100644 (file)
--- a/drivers/video/savage/savagefb-i2c.c
+++ b/drivers/video/savage/savagefb-i2c.c
@@ -170,9 +170,8 @@ void savagefb_create_i2c_busses(struct fb_info *info)
        struct savagefb_par *par = info->par;
        par->chan.par   = par;
 
-       switch(info->fix.accel) {
-       case FB_ACCEL_PROSAVAGE_DDRK:
-       case FB_ACCEL_PROSAVAGE_PM:
+       switch (par->chip) {
+       case S3_PROSAVAGE:
                par->chan.reg         = CR_SERIAL2;
                par->chan.ioaddr      = par->mmio.vbase;
                par->chan.algo.setsda = prosavage_gpio_setsda;
@@ -180,7 +179,7 @@ void savagefb_create_i2c_busses(struct fb_info *info)
                par->chan.algo.getsda = prosavage_gpio_getsda;
                par->chan.algo.getscl = prosavage_gpio_getscl;
                break;
-       case FB_ACCEL_SAVAGE4:
+       case S3_SAVAGE4:
                par->chan.reg = CR_SERIAL1;
                if (par->pcidev->revision > 1 && !(VGArCR(0xa6, par) & 0x40))
                        par->chan.reg = CR_SERIAL2;
@@ -190,7 +189,7 @@ void savagefb_create_i2c_busses(struct fb_info *info)
                par->chan.algo.getsda = prosavage_gpio_getsda;
                par->chan.algo.getscl = prosavage_gpio_getscl;
                break;
-       case FB_ACCEL_SAVAGE2000:
+       case S3_SAVAGE2000:
                par->chan.reg         = MM_SERIAL1;
                par->chan.ioaddr      = par->mmio.vbase;
                par->chan.algo.setsda = savage4_gpio_setsda;