pinctrl: Keep enum pin_config_param ordered by name

It seems the ordering is by name. Keep it that way.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Link: https://lore.kernel.org/r/20210412140741.39946-1-andriy.shevchenko@linux.intel.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 6aeb711..188db8d 100644 (file)
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -90,6 +90,7 @@ struct pinctrl_map;
  *     value on the line. Use argument 1 to indicate high level, argument 0 to
  *     indicate low level. (Please see Documentation/driver-api/pinctl.rst,
  *     section "GPIO mode pitfalls" for a discussion around this parameter.)
+ * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
  *     supplies, the argument to this parameter (on a custom format) tells
  *     the driver which alternative power source to use.
@@ -101,7 +102,6 @@ struct pinctrl_map;
  *     or latch delay (on outputs) this parameter (in a custom format)
  *     specifies the clock skew or latch delay. It typically controls how
  *     many double inverters are put in front of the line.
- * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
  *     you need to pass in custom configurations to the pin controller, use
  *     PIN_CONFIG_END+1 as the base offset.
@@ -127,11 +127,11 @@ enum pin_config_param {
        PIN_CONFIG_LOW_POWER_MODE,
        PIN_CONFIG_OUTPUT_ENABLE,
        PIN_CONFIG_OUTPUT,
+       PIN_CONFIG_PERSIST_STATE,
        PIN_CONFIG_POWER_SOURCE,
        PIN_CONFIG_SLEEP_HARDWARE_STATE,
        PIN_CONFIG_SLEW_RATE,
        PIN_CONFIG_SKEW_DELAY,
-       PIN_CONFIG_PERSIST_STATE,
        PIN_CONFIG_END = 0x7F,
        PIN_CONFIG_MAX = 0xFF,
 };